How much is ball joints for a Honda?

The cost of ball joints for a Honda can vary depending on factors such as the specific model of the Honda and whether you are purchasing original equipment manufacturer (OEM) parts or aftermarket parts. According to search results, the cost of replacing one lower ball joint for a 2003 Honda Civic can range from $316 to $365 using aftermarket parts, and from $338 to $365 using factory parts. The cost of replacing both lower ball joints for the same vehicle can range from $316 to $338 using aftermarket parts, and from $338 to $365 using factory parts.
It’s important to note that these are just estimates and the actual cost may vary depending on various factors such as the location and the specific Honda model. It is recommended to consult with a professional mechanic or refer to the vehicle’s manual for more accurate and specific cost estimates for your Honda model.

How much should ball joints cost to replace?

For mainstream cars, the estimated replacement cost for a single ball joint ranges from $200 to $350, including parts and labor. Non-greaseable ball joints are more affordable, costing between $100 and $200, but have a shorter service life. Greaseable ball joints offer extended durability, ranging from $150 to $350.

Should I replace all 4 ball joints?

This means that if you have a problem with your ball joint, the entire assembly will usually need to be replaced.

Is it OK to drive with a bad ball joint?

What are the risks of driving with a bad ball joint? A worn ball joint is not a problem that should be ignored. If the wear becomes severe, the stud may separate from the housing resulting in immediate loss of control of your vehicle.

Are ball joints easy to fix?

If you suspect ball joint wear, the car should be inspected as soon as possible. Ball joint replacement is not straightforward, as they can be very tricky to access and install – especially with age and rust.

Can you replace just the ball joint without replacing control arm?

In the case of a ball joint mounted on a cast track control arm you can often settle for only replacing the ball joint if the bushings of the track control arms do not show signs of wear and tear.

What are the symptoms of a bad ball joint?

Signs of a Bad Ball Joint

• Clunking Noises. When a ball joint is slightly loose, an occasional clunking noise can happen when you’re driving over uneven surfaces or while turning.
• Steering Wander.
• Uneven Tire Wear.
• Vibration.
• Steering Difficulty.

Is replacing ball joints a big job?

Ball joint replacement is not straightforward, as they can be very tricky to access and install – especially with age and rust.

Is it worth replacing ball joints?

A broken ball joint may be the cause of a mysterious clunking noise or drifting steering. And once they’re worn, they will seriously affect your steering and suspension. If a ball joint fails completely, it can even result in the wheel dramatically falling off the car.

Are ball joints easy to replace?

Ball joint replacement is not straightforward, as they can be very tricky to access and install – especially with age and rust. On some cars, the ball joint is integrated into the control arm. If you’re not familiar with the suspension and wheel assembly, it’s best to visit a garage for a professional check.

How long can I drive with a bad ball joint?

How far should you drive with a broken ball joint? The quick and short answer is ZERO, Zero, you should drive Zero miles with a broken ball joint.