How much does it cost to replace a wheel bearing on a Dodge Caliber?

Cost of Replacing a Wheel Bearing on a Dodge Caliber
The cost of replacing a wheel bearing on a Dodge Caliber ranges between $329 and $364 on average. This estimate includes the cost of the part and the labor charges in your area. It’s important to note that the cost may vary based on the specific make and model of the vehicle, as well as the prevailing labor charges in different regions.
In some cases, the wheel hub and bearing can be replaced as a unit, while in others, they are pressed together into the knuckle and require special tools for removal. The process involves putting the car on a lift, removing the wheel and tire, and then removing the brake caliper and rotor before replacing the wheel bearing.
It’s advisable to get a detailed estimate for the repair in your specific area to have a more accurate understanding of the total cost involved.

Is fixing a wheel bearing a big job?

The bearing comes out of the hub assembly and a new one goes in its place. This repair is not labor intensive under normal circumstances and the parts are fairly inexpensive.

Is changing a wheel bearing a big job?

This not only takes more time, but also requires additional materials for example, a new car wheel hub. Normally, a wheel bearing can be changed in about 45 to 60 minutes, depending on the model. If the bearing is stuck, the time required can double.

What are the first signs of bearing failure?

If your bearing is suddenly noisy during operation, you’re looking at a bearing failure. This excess noise is created when the raceways of the bearing have become damaged, causing the rolling elements to bounce or rattle during rotation.

How long will a wheel bearing last once it starts making noise?

But on average a wheel bearing can last 200 to 1000 miles after it starts to make noise wheel bearing noise symptoms are usually indications of different faults in the car.

How long does it take a mechanic to fix a wheel bearing?

The time taken to replace a wheel bearing is also slightly different depending on whether the bearing is on the front or rear wheel. A front wheel bearing replacement on average takes around 90 minutes, whereas a rear wheel bearing replacement takes on average just under 1 hour.

Can I drive with a bad wheel bearing?

Can I drive with a bad wheel bearing? No, it can be very dangerous. The bearings can cause a severe problem if they malfunction. As we said before, extreme heat can be caused by friction, and this can cause a sudden seize of the bearing, causing the wheel to get blocked at whatever speed we are driving at that moment.

How many hours does it take to replace a wheel bearing?

Replacing a single wheel bearing can take 90 to 120 minutes depending on the type of vehicle and complexity. There are a lot of moving parts that need to be maintained and properly sealed to complete this type of work.

How much should a wheel bearing job cost?

What does it cost to replace wheel bearings? The cost to replace one front-wheel hub assembly varies widely. Some variables include the make and model, the garage’s labor rate and the cost for parts. The national average is about $350 to fix the wheel bearings at one wheel.

What are signs of a bad wheel bearing?

Watch out and listen for these signs:

• Humming Noise. The most easily identifiable and common symptom of bad wheel bearings is audible.
• Squealing, Growling.
• Clicking Sound.
• Wheel Wobble.
• ABS Failure.
• Uneven Tire Wear.
• Vehicle Pulls to One Side.
• Steering Wheel Vibration.

How long will a noisy wheel bearing last?

A noisy wheel bearing will typically last anywhere from a few more minutes, long enough to get off the road most times, to a few hundred miles, depending on the noise.