AHG Auto Service » Make » Dodge » How much does it cost to replace a water pump in a Dodge Nitro?

How much does it cost to replace a water pump in a Dodge Nitro?

The cost to replace a water pump in a Dodge Nitro can vary depending on various factors such as the location, the specific model of the Nitro, and the labor rates of the repair shop. According to the search results, the average cost of a Dodge Nitro water pump replacement is between $494 and $627. However, it’s important to note that this is just an estimate and the actual cost may vary. It is recommended to get a detailed estimate from a repair shop in your area for an accurate cost specific to your situation.

Is changing a water pump a big job?

Your shop is correct that the labor time to replace the water pump is about five hours. Today we are seeing shop labor rates from $100-$175 per hour, so costs escalate quickly. I would replace the drive belts, and perhaps the belt tensioners while replacing the water pump.

How many hours does it take to replace a water pump?

two to three hours
The water pump may be hidden under other components and may require special tools depending on the vehicle’s design. It’s a repair that can take two to three hours. Some mechanics recommend water pump replacement as preemptive maintenance when the timing belt is changed.

How does a car act when the water pump is going out?

Hot air inside your car by a blower motor. If the water pump fails it will never be able to circulate coolant to your heater core resulting in poor heating. Performance.

Is it worth fixing a water pump on a car?

An overheating engine often happens when the water pump isn’t circulating the coolant throughout the engine. As we stated earlier, a failing water pump can cause serious engine damage if you don’t get a water pump replacement soon. Oil and water don’t mix!

Is it OK to drive with a bad water pump?

It is not advisable to drive a car with a bad water pump. Signs of a bad water pump like leakage, smoke, and overheating should be addressed with immediate effect. A completely damaged water pump can cause a complete engine failure. Replacing a water pump is the solution to all these problems.

How long can you drive with a bad water pump?

You can drive until the pump seizes, and you burn up the serpentine belt and lose your alternator and power steering, and your engine overheats to destruction. You can drive while the pump leaks coolant until the coolant level falls below the level of the impeller, and your engine overheats to destruction.

How can I tell if the water pump is bad?

Itself might not be the source of the noise. The sound could be the result of a failing water pump pulley or a loose drive belt. Another classic sign of a failing water pump is coolant leakage.

How many miles can you drive with a broken water pump?

You might go a couple of miles on a good road before you seriously damage the engine from overheating, which is far enough to find a safe place to pull over in most cases.

How long can a car run with a bad water pump?

You might go a couple of miles on a good road before you seriously damage the engine from overheating, which is far enough to find a safe place to pull over in most cases. Until your car overheats, blows a head gasket and warps the heads.

When replacing a water pump what else should you replace?

Definitely Replace:

  1. Water pump (obviously)
  2. Timing belt.
  3. Crankshaft bolt.
  4. Drive belt(s) for alternator, power steering pump, AC compressor.
  5. Upper and lower radiator hoses.
  6. Coolant / Antifreeze.
AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment