How much does it cost to replace a tie rod on a Ford Taurus?

Cost to Replace a Tie Rod on a Ford Taurus
If you’re considering replacing a tie rod on your Ford Taurus, the cost can vary based on several factors. According to the search results, the average cost for a Ford Taurus tie rod replacement ranges from $131 to $143 on average. However, the total cost can depend on the specific part that needs replacement, such as the inner tie rod or the outer tie rod, as well as the cost of parts and labor. Typically, the total cost can range from $100 to $400 for a tie rod replacement .
It’s important to note that the cost estimates can vary based on the specific vehicle and the type of tie rod that needs replacement. For instance, replacing the inner tie rod end is generally more expensive than replacing the outer tie rod end, as it requires special tools and more effort. Additionally, if the front wheel alignment is off, this could add another $80 to $100 to the total bill.
In summary, the cost to replace a tie rod on a Ford Taurus can range from $100 to $400, depending on various factors such as the specific part needing replacement, the cost of parts and labor, and any additional alignment adjustments that may be necessary.
Remember to consult with a qualified mechanic for a detailed estimate based on your specific vehicle and the type of tie rod that needs replacement.

Are tie rods easy to replace?

Replacing tie rod ends refers to repairing an integral part of a vehicle’s steering mechanism. With a few basic tools and a little bit of know-how, this is a procedure that anyone, with a little bit of automotive experience, can perform on their own.

How much should a tie rod replacement cost?

The cost of replacing a tie rod depends on the type of vehicle, the parts’ scarcity, and the quality. The average cost ranges from $100 to $400. However, expect to pay more for luxury and high-end vehicles. It would be best if you always replaced tie rods in pairs.

Do you need an alignment after replacing tie rods?

If you have rack and pinion-type inner and outer tie rods, you can often remove and replace them without upsetting the vehicle’s alignment specs. However, you will need to have an alignment done after replacing the outer tie rods.

Is it OK to replace just one tie rod?

Ideally, YES – if the concern is excessive wear. However, sometimes a ball joint which might be otherwise in good condition (that is, not worn) can be damaged as a result of an accident or impact. If the damage does not affect both tie rod ends, you can usually replace just one. Though a thorough inspection is advised.

Do I need an alignment after replacing tie rods?

If you have rack and pinion-type inner and outer tie rods, you can often remove and replace them without upsetting the vehicle’s alignment specs. However, you will need to have an alignment done after replacing the outer tie rods. You should still try to keep the alignment specs in line as much as possible.

What noise does a bad tie rod end make?

When your tie rods go bad, the symptom you’re most likely to experience first is a vibration or shaking sensation in your steering wheel. You may also hear associated clunking and rattling noises, especially when turning the vehicle at low speeds. These sounds are caused by tie rods that are starting to wear out.

How many hours does it take to replace tie rods?

As with many other vehicle repair questions, the answer is – it depends. The price of tie rods, parts and labor can vary from vehicle to vehicle. The average car can probably get a tie rod replaced in about an hour labor plus about $80 for the part, so about $170.

Is it OK to drive with a bad tie rod end?

In the worst case scenario when a tie rod completely fails, the wheel will break free of the steering assembly which then causes the vehicle to lose the ability to steer. At the first sign of any wear to the tie rods, steering is already at risk and the vehicle is not safe to drive.

What are the symptoms of a bad tie rod?

Common signs include a steering wheel that shakes or vibrates and looseness or excessive play in the steering wheel. The vibration typically becomes worse as you accelerate or turn. Don’t wait for your steering issues to become worse; get your vehicle to a qualified technician as soon as you notice these issues.

Are tie rods easy to fix?

Replacing tie rod ends refers to repairing an integral part of a vehicle’s steering mechanism. With a few basic tools and a little bit of know-how, this is a procedure that anyone, with a little bit of automotive experience, can perform on their own.