AHG Auto Service » Make » Honda » How much does it cost to replace a ball joint on a Honda?

How much does it cost to replace a ball joint on a Honda?

The cost to replace a ball joint on a Honda can vary depending on factors such as the make, model, and year of the vehicle, as well as the type of ball joint used. According to the search results, the estimated cost for replacing a single ball joint on a mainstream car, including parts and labor, ranges from $200 to $350. However, for specific Honda models, such as a 2003 Honda Civic, the cost of replacing a front lower ball joint is estimated to be around $365 using factory parts or about $355 using aftermarket parts. It’s important to note that these are just estimates, and the actual cost may vary based on various factors such as the location of the repair shop and additional services required.

What are the symptoms of a bad ball joint?

Signs of a Bad Ball Joint

  • Clunking Noises. When a ball joint is slightly loose, an occasional clunking noise can happen when you’re driving over uneven surfaces or while turning.
  • Steering Wander.
  • Uneven Tire Wear.
  • Vibration.
  • Steering Difficulty.

What mileage do ball joints go bad?

70,000 to 150,000 miles
Ball joints typically last 70,000 to 150,000 miles depending on their usage and road conditions. Clunking noises, poor handling, pulling, and abnormal wearing of your tires are all signs of a worn ball joint. If you see uneven tread wear patterns on your tire, you should have your ball joints checked.

How many hours does it take to replace a ball joint?

How long does it take to replace a ball joint? The time required to change a ball joint can vary depending on how much work needs to be done, but it generally takes a mechanic between two and four hours.

What does a worn out ball joint sound like?

Noise – this can be a clunking or squeaking noise. Clunking noises are caused by the worn ball joints rattling as the suspension travels up and down over the road. The squeaking noise is caused by the rubber boot that protects the grease inside the ball joint is damaged, the ball joint will start to squeak.

Is replacing ball joints a big job?

Ball joint replacement is not straightforward, as they can be very tricky to access and install – especially with age and rust.

Is a ball joint expensive to fix?

Non-greaseable ball joints are more affordable, costing between $100 and $200, but have a shorter service life. Greaseable ball joints offer extended durability, ranging from $150 to $350. Luxury or high-performance vehicles with complex suspension systems may incur higher replacement costs, exceeding $350.

How long can I drive with a bad ball joint?

How far should you drive with a broken ball joint? The quick and short answer is ZERO, Zero, you should drive Zero miles with a broken ball joint.

Do you need an alignment after replacing ball joints?

There’s no denying that it’s very important to replace your ball joints when needed. However, it’s worth noting that doing that doesn’t necessarily mean you need an alignment. The only time you need one after replacing the ball joints is if the previous alignment was performed when ball joints were not in good shape.

Is it OK to drive with a bad ball joint?

What are the risks of driving with a bad ball joint? A worn ball joint is not a problem that should be ignored. If the wear becomes severe, the stud may separate from the housing resulting in immediate loss of control of your vehicle.

Is it worth replacing ball joints?

A broken ball joint may be the cause of a mysterious clunking noise or drifting steering. And once they’re worn, they will seriously affect your steering and suspension. If a ball joint fails completely, it can even result in the wheel dramatically falling off the car.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment