How much coolant does a 2008 Toyota Highlander take?

Based on the information from the search results, a 2008 Toyota Highlander takes a little over a gallon of coolant for a simple drain and fill of just the radiator. If the vehicle has a factory tow package and HD radiator, it may require more coolant, but the exact amount is not specified.
Please note that it is always recommended to consult the owner’s manual or contact a Toyota dealership for the most accurate and specific information regarding your vehicle’s coolant capacity.
If you need to add coolant to your 2008 Toyota Highlander, it is important to check your owner’s manual to determine the correct type of coolant to use. In Toyotas, this information is usually located in a section titled “Fluid Capacities” towards the end of the manual.
Remember to always check the coolant level when the engine is cool to the touch for an accurate reading.
I hope this helps! Let me know if you have any other questions.

How many gallons of coolant does a 2008 Toyota Camry take?

It takes about 2 gallon of coolant for flush and replace. I was wonder if I just buy any coolant from parts shop or buy 1 gallon of 100% coolant so I will have 2 gallon by mixing it with distill water or should I stick to manual and fork out 2 gallons of 50/50 diluted coolant.

How many gallons of antifreeze do I need after a flush?

Most vehicles need 1–1.5 gallons of pure coolant after flushing, check owner manual if need be.. I only use a flush for extremely corroded systems. I drain, fill with water and drive it, letting the water system flush the system for up to 1 week with a weak coolant solution.

How much antifreeze does it take to fill up?

How much coolant your car holds and thus will require depends entirely on its engine and cooling system. A relatively small displacement 4-cylinder engine could contain as few as six or seven quarts, while a large American V-8 engine might hold more than 16 quarts.

How much coolant does a 2009 Toyota Camry hold?

Coolant

Capacity:	Power Control Unit Initial fill 3.1 quarts.
Capacity:	Engine Initial fill 6.6 quarts.

How much coolant does my car need when empty?

How much coolant is needed in a car? The average car’s cooling system holds about 5 litres of coolant – and most vehicles require between 3 and 7 litres of coolant at a time.

How often should you change the coolant in a Toyota Highlander?

Typically, you should have your Toyota Highlander coolant flush completed every 30,000 miles or every two years.

How do I know if my car needs more coolant?

How to Know if Your Car Needs Coolant

1. Warning light on the dash.
2. A sweet smell coming from the engine.
3. Reduced gas mileage.
4. Puddle under your car with orange, green, or pink fluid.
5. The heater isn’t working properly.
6. The temperature gauge needle is inaccurate.

What kind of coolant does a Toyota Highlander take?

Pentosin – Pentofrost A4 HOAT Phosphated Asian 50/50 Prediluted Antifreeze / Coolant – 1 Gallon (Part No. 8115209) Pentofrost A4 is a phosphated organic acid technology (phosphated OAT); which is categorized as HOAT (hybrid organic acid technology) in the US market.

How much coolant do I use?

Typically, a passenger car with a standard-sized radiator may require around 5-11 litres of coolant to fill the engine’s cooling system. To get an accurate measurement of how much coolant your car’s radiator needs, it’s essential to consult your vehicle’s owner’s manual.

How much coolant does a 2005 Toyota Highlander take?

Coolant

Capacity:	With O RR Heater Initial fill 9.9 quarts.
Capacity:	With O RR Heater With TT Initial fill 10.7 quarts.
Capacity:	With RR Heater & Tow PKG Initial fill 12 quarts.
Capacity:	With Rear Heater Initial fill 11.3 quarts.