AHG Auto Service » Make » Ford » How many quarts of transmission fluid does a Ford Freestar take?

How many quarts of transmission fluid does a Ford Freestar take?

Transmission Fluid Capacity for Ford Freestar
The amount of transmission fluid needed for a Ford Freestar can vary depending on the specific model and year. Here are the capacities for different models:
– The 2006 Ford Freestar has the following transmission fluid capacities:
– Automatic Transmission, E4OD Initial Fill: 6.5 quarts
– Automatic Transmission, C6 Initial Fill: 6 quarts
– Automatic Transmission, 4R70W Initial Fill: 5 quarts
– Automatic Transmission, 4R75W Initial Fill: 5 quarts
– Automatic Transmission, Total Fill 4 speed E4OD: 15.7 quarts
– 4 speed 4R70W: 14 quarts
– 3 speed C6: 12.1 quarts
– 4 speed 4R75W: 14 quarts.
– A user who replaced the filter and pan gasket in a 2004 Ford Freestar reported that it drained out 8 quarts, and they put in 8 quarts, which worked perfectly.
– The exact amount needed for a transmission fluid change may vary, and it’s recommended to start by adding four quarts, then start the vehicle and top off as needed, followed by a test drive to confirm the proper level.
Given these varying reports, it’s advisable to consult the specific model’s manual or a certified mechanic for the most accurate information.

What kind of oil does a 2006 Ford Freestar use?

Notes: Full synthetic. 5W-20. 1 quart.

How much transmission fluid does a Ford Freestar hold?

13.7 quarts
Automatic Transmission Fluid
Capacity: 4 speed AX4N Total Fill 13.7 quarts.

How many quarts are needed for a transmission fluid change?

Drivers can expect to pay $125 to $250 for a transmission fluid flush service. This is approximately twice as much as a transmission fluid change. This is due in large part to the additional fluid required. A flush will take 12 to 22 quarts, while a fluid change requires 5 to 7 quarts.

How many quarts of transmission fluid does a Ford Freestyle take?

Automatic Transmission Fluid
Capacity: CFT30 Total Fill 10.1 quarts.

How many quarts of transmission fluid does it take to fill?

In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much. It is advisable to put in little amounts at a time.

How much transmission fluid does a 2007 Ford e250 take?

For Automatic Transmission: 4R75E….MA5

Capacity: 4 speed 4R75E Total Fill 13.9 quarts.
Capacity: 5 quarts Initial Fill.

How much transmission fluid does a 2007 Ford Ranger take?

10 quarts
Automatic Transmission Fluid
Capacity: 5 speed RWD 5R55E Total Fill 10 quarts. Capacity: 5 speed 4WD 5R55E Total Fill 10.4 quarts.

What transmission is in a Ford Freestar?

Actually the windstar only offered a 3.8 liter engine, and the freestar offered the 3.9 and the 4.2 liter engine however the transmissions in these two model years are identical and interchangeable, the 4F50N (AX4N) automatic transaxle in the 2002 windstar and the 2004 freestar are the same!

How many quarts of transmission fluid does a 2006 Ford Freestar take?

Automatic Transmission Fluid
Capacity: 4 speed AX4N Total Fill 12.3 quarts.

How much oil does a 2007 Ford Freestar 4.2 take?

Oil Grade: SEO15

Viscosity: All TEMPS….5W-20
Capacity: With filter 5 quarts. After refill check oil level.
Torque: Oil Drain Plug…19 ft/lbs
AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment