Oil Capacity of a 2004 Ford Freestar
The 2004 Ford Freestar typically requires approximately 8 quarts of transmission fluid when replacing the filter and pan gasket. It’s recommended to start by adding four quarts, then start the vehicle and top off as needed, followed by driving it around and checking again after a test drive to confirm the proper level.
It’s important to note that the transmission fluid capacity can vary based on the specific maintenance procedures and the individual vehicle’s needs. Therefore, it’s always best to consult the vehicle’s manual or a trusted mechanic for the most accurate information.
If you have any more questions or need further assistance, feel free to ask!
Contents
- How many quarts are needed for a transmission fluid change?
- How many miles per gallon does a 2004 Ford Freestar get?
- How many quarts does a 2004 Ford Ranger take?
- How many quarts of transmission fluid does a Ford Freestar take?
- What is the best oil for a 2004 Ford Freestar?
- How many quarts of oil does a Ford Ranger need?
- Can I use 5w30 instead of 5w20 in my Ford?
- What oil does a Ford Freestar take?
- How many quarts of transmission fluid for a 2004 Ford Freestar?
- How much oil does a 2004 Ford Ranger 3.0 take?
How many quarts are needed for a transmission fluid change?
Drivers can expect to pay $125 to $250 for a transmission fluid flush service. This is approximately twice as much as a transmission fluid change. This is due in large part to the additional fluid required. A flush will take 12 to 22 quarts, while a fluid change requires 5 to 7 quarts.
How many miles per gallon does a 2004 Ford Freestar get?
It makes 201 horsepower and is mated to a four-speed automatic transmission. The Environmental Protection Agency rates that combination at 16 miles per gallon in city driving and 22 mpg on the highway.
How many quarts does a 2004 Ford Ranger take?
5 quarts
Capacity: With filter 5 quarts. When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level.
How many quarts of transmission fluid does a Ford Freestar take?
13.7 quarts
Automatic Transmission Fluid
Capacity: 4 speed AX4N Total Fill 13.7 quarts.
What is the best oil for a 2004 Ford Freestar?
2004 FORD FREESTAR Motor Oil
- Valvoline Full Synthetic High Mileage with MaxLife Technology Motor Oil SAE 5W-20.
- Valvoline Extended Protection Full Synthetic High Mileage Motor Oil SAE 5W-20.
- Valvoline Daily Protection Synthetic Blend Motor Oil SAE 5W-20.
- Valvoline Advanced Full Synthetic Motor Oil SAE 5W-20.
How many quarts of oil does a Ford Ranger need?
6.2 quarts
With filter 6.2 quarts. After refill check oil level.
Can I use 5w30 instead of 5w20 in my Ford?
In 2011, Ford started recommending 5w30 for the turbocharged 3.5 Ecoboost engines, but they haven’t changed the recommendation for the non-turbo duratec. You can run both 5w20 or 5w30 safely on these engines (turbocharged and non-turbo). Both oils will work great.
What oil does a Ford Freestar take?
Castrol – GTX High Mileage 5W-20 Synthetic Blend Motor Oil: 5 Quart (Part No. 1597C4)
How many quarts of transmission fluid for a 2004 Ford Freestar?
Automatic Transmission Fluid
Capacity: 4 speed AX4N Total Fill 13.7 quarts.
How much oil does a 2004 Ford Ranger 3.0 take?
4.5 quarts
Capacity: With filter 4.5 quarts.