How long do wheel bearings last Subaru Impreza?

How long do wheel bearings last in a Subaru Impreza?
The lifespan of wheel bearings in a Subaru Impreza can vary depending on various factors. According to the search results, wheel bearings usually have a lifespan of around 80,000 to 100,000 miles, and some may last up to 150,000 miles. However, it’s important to note that there is no standard maintenance schedule for wheel bearing replacement. The lifespan can be affected by factors such as driving conditions, frequency of driving over potholes or speed bumps, and exposure to water, dust, and other contaminants that can affect the lubrication of the bearings.
It’s worth mentioning that some Subaru owners have reported experiencing wheel bearing issues with their vehicles, while others have had no problems at all. The experiences can vary depending on individual driving habits and maintenance practices.
If you notice any signs of wear or damage to your wheel bearings, such as excessive vibration in the steering wheel, pulling to one side, or unusual noises, it is recommended to have them inspected and replaced if necessary. Delaying a replacement could lead to further damage to other components of the vehicle, such as the hub assembly, CV joint, or transmission, which can be more expensive to repair.
It’s always a good idea to consult with a trusted mechanic or refer to the owner’s manual for specific maintenance recommendations for your Subaru Impreza.

What is the life expectancy of a wheel bearing?

approximately 85,000-100,000 miles
As mentioned previously, the average life of wheel bearings is approximately 85,000-100,000 miles. However, that lifespan can be shortened if you hit a curb, speed bump, or pothole at high speeds. Contamination from water, mud, road salt, or sand can also shorten the life of your wheel bearings.

Do Subarus have wheel bearing issues?

Subaru wheel bearing replacement is a common requirement especially for older Subaru models that don’t have the type 2 bearing design.

How long do wheel bearings last on a Subaru?

How long does a wheel bearing last? Wheel bearings have an average lifespan of 136,000 to 160,000 km (approximately 85,000 to 100,000 miles). This is only a rule of thumb though, the actual lifespan of a wheel bearing depends on the quality of the wheel bearing and the operating conditions.

Should I replace all 4 wheel bearings at once?

You should expect to replace wheel bearings every 85,000-100,000 miles. However, this number is only a guess, as it also depends on the quality of the bearings. Unless both bearings on all side of the wheels are overworked, there is no need to replace them all at once. You should only swap out the ones that need it.

How do I know if my Subaru wheel bearings are bad?

Watch out and listen for these signs:

1. Humming Noise. The most easily identifiable and common symptom of bad wheel bearings is audible.
2. Squealing, Growling.
3. Clicking Sound.
4. Wheel Wobble.
5. ABS Failure.
6. Uneven Tire Wear.
7. Vehicle Pulls to One Side.
8. Steering Wheel Vibration.

How much does it cost to replace wheel bearings on a Subaru Impreza?

The average cost for Subaru Impreza Wheel Bearing Replacement is $378.

Can I drive slowly with bad wheel bearing?

How many miles can you drive on a bad wheel bearing? The lesser, the better. As we said before, this issue can lead to a very dangerous situation. If it’s unavoidable, the most appropriate way to do so is to drive as slow as possible to minimize the friction.

Do Subarus have wheel bearing problems?

Subaru wheel bearing replacement is a common requirement especially for older Subaru models that don’t have the type 2 bearing design.

Why do Subaru bearings fail?

With the Subaru EJ engines having such a small oil capacity, the oil gets saturated with combustion by products and other engine material sooner. This dirty oil wreaks havoc on bearings and causes them to wear prematurely. With the bearings already being at a disadvantage due to their size, wear also occurs sooner.

What are the first signs of bearing failure?

If your bearing is suddenly noisy during operation, you’re looking at a bearing failure. This excess noise is created when the raceways of the bearing have become damaged, causing the rolling elements to bounce or rattle during rotation.