How do you test mode on a Ford C-Max?

To access the test mode on a Ford C-Max, you can follow these steps:
1. Enter Test Mode: Turn the ignition to the ON position without starting the engine. When you see “TEST” on the display, release the OK button.
2. Perform Self-Diagnostic Tests: Once in test mode, you can access various tests like needle sweep test, diagnostic tests, read DTC fault codes, check indicators and LCD display, engine RPMs, and fuel flow by using the arrow button to navigate through diagnostic mode.
3. Exit Self-Diagnostic Mode: To exit the self-diagnostic mode, turn the ignition to the OFF position.
It’s important to note that these steps are based on the Ford owner’s manual and should work for the third generation of Ford C-Max (2011-2019) model years.
Remember to exercise caution and follow the instructions carefully when performing these tests.

What is engineering test mode?

You can use engineering test mode to adjust the average fuel economy bias (AFEB) number the computer uses to compute and display mileage. If your car is like mine, you may have noticed the displayed mileage is significantly different from actual.

How do I manually reset my car computer?

You should wait four or five minutes so all the electricity is drained. Then just get the negative terminal and bolt it back on.

Why did Ford discontinue the C-MAX?

Ford is dropping the Grand C-Max, shown, because of a sharp drop in demand as customers switch to SUVs and crossovers. Ford confirmed it will end production of its C-Max minivan at its factory in Saarlouis, Germany, but said the plant will stay open with further investment in the Focus car that is also built there.

What are the common faults on Ford C-Max?

Ford C-Max Common Problems and Solutions

• Passenger Door won’t Lock. Problem:
• Turbo Malfunction (All Turbo Models) Problem:
• Burnt Out Headlights. Problem:
• Clutch is Slipping. Problem:
• Slippery driving. Problem:
• Car taking too much fuel and lacking power. Problem:
• Rear brakes. Problem:
• External boot release button. Problem:

How do I reset my Ford C-Max computer?

The procedure I found to follow is :

1. Disconnect negative battery terminal and let the vehicle sit for 1 hour.
2. Reconnect the battery, start the car (don’t even think of touching the gas!!).
3. Let it idle for at least ten to fifteen minutes.
4. Turn engine off, turn back on and go for a hard drive. Bounce it off.

What is test mode for?

A Test Mode is a secret mode hidden in an electronic device that allows a manufacturer to test the product before it gets sent to the consumer. A consumer can access the test mode by pressing some buttons and either inserting the battery or holding down and letting go of the reset button.

What is a master reset on Ford?

Doing. So will completely erase all information stored. On your sync 3 and sync connect system back to the factory default settings. Including all of your paired Bluetooth devices.

What is the life expectancy of the Ford C-Max?

The estimated lifespan of a Ford Focus C-max is 174,000mi, before reaching the life expectancy upper limit. Fuel type is a major factor when looking into a vehicles lifespan/life expectancy. Don’t just buy it, VehicleScore it.

How does test mode work?

Test Mode allows the merchant to toggle their entire active gateway account into and out of Test Mode. While in Test Mode, merchants can submit test transactions to the Payment Gateway. Test transactions that are submitted while the account is in Test Mode are not live and do not charge real credit cards.

What is the L mode on a Ford C-Max?

Again, per the C max energi owner’s manual, shifting to L only increases the engine braking effect. It does not increase the pedal off regen or the total regen. It is all in the manual. Drving the Cmax, energi or not, in L will make your fuel economy worse and keep the engine on.