AHG Auto Service » Make » Toyota » How do you reset the TYRE pressure light on a Toyota Yaris?

How do you reset the TYRE pressure light on a Toyota Yaris?

How to Reset the Tire Pressure Light on a Toyota Yaris
To reset the tire pressure light on a Toyota Yaris, you can follow these steps:
1. Check Tire Pressure and Address Any Issues: Ensure that your tires are properly inflated. If you’ve had your tires inflated but the tire pressure light remains on, you may need to reset it.
2. Resetting the Tire Pressure Monitoring System (TPMS):
– The Toyota Yaris uses an indirect tire pressure monitoring system, which means it uses data sent from the ABS wheel speed sensors. The system must be reset in the following instances:
– A tire pressure has been adjusted.
– A tire or wheel has been replaced.
– Tire rotation has occurred.
– The vehicle battery has been replaced or recharged after being completely discharged.
– Any time the tire pressure monitoring warning light is illuminated.
3. Reset Procedure:
– If your Toyota Yaris is equipped with a TPMS reset button, you can follow these steps to reset the TPMS warning light:
– Wait for several minutes with the engine switch in the ON position to allow the system to record each tire’s pressure, then turn the engine off.
4. Alternative Method:
– Some users have reported success with disconnecting the battery for a few minutes and then reconnecting it to solve the problem of the tire pressure warning light remaining on.
5. Additional Tips:
– It’s important to note that the TPMS alarm does not “latch” on, and the car will cancel the alarm within a few minutes after you drive away if the tire pressure is corrected.
Remember to consult your Toyota Yaris owner’s manual for specific instructions on resetting the tire pressure warning light.
Always ensure that your tire pressure is at the recommended levels for safe driving and optimal vehicle performance.

Where is the Toyota tire pressure reset button?

It is typically located beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. Once you’ve found the TPMS reset button, press and hold it for approximately three seconds. You may need a pen or a similar tool to reach it.

How do I manually reset my TPMS light?

Drive at or above 50 mph to reset the sensor for 10 minutes. This causes your sensor to reset the next time you turn on your car. With the vehicle off, turn the key to the “On” position, but do not start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it.

Where is the TPMS reset button on a Toyota Yaris?

And the light will flash. One. Two three sorry put the ignition. On which brings the lights.

Why won t my tire pressure light go off even though pressure is fine?

If the light remains on after adjusting the tire to the proper PSI, you may need to repair your tire, have your TPMS inspected, or try one of the following: Go for a 10-minute drive. Get up to 50 MPH, if possible. Your vehicle may be equipped with a TPMS reset button or reset procedure in your vehicle control center.

Where is the tire pressure reset button located?

Set the parking brake. Look for a button to the left of the steering column labeled with the TPMS icon if it’s there push and hold it until the TPMS indicator in the instrument panel blinks twice.

Where is the Toyota TPMS button?

You’ll find it low and to the right of the steering wheel on the instrument panel. Hold the button down until the TPMS indicator light in the instrument panel blinks slowly 3 three times. Wait for several minutes with the engine running, to allow the system to record each tire’s pressure, then turn the engine off.

Why is my tire pressure light on even though I filled my tires?

The causes can be a malfunction, or the weather changes. Other reasons why your TPMS light may still be blinking is because your tire may be damaged, or you might have gotten a recent tire replacement. Overall, the reasons can be vast, which is why it is best to take your car to a technician for professional diagnosis.

How long does it take for the check tire pressure light to go off?

After about 20 minutes of driving, the air will often warm up and expand, restoring proper pressure in your tires. If the light stays on after 20 minutes on the road, you should add air to your tires as needed to restore the proper pressure. Low tire pressure is hazardous for your vehicle regardless of the cause.

Can I reset my TPMS myself?

Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait about 20 minutes for the sensor to refresh. You will find the tire pressure monitor reset button under the steering wheel. Refer to your vehicle’s owner’s manual if you can’t find it.

Where is the TPMS button located?

The TPMS reset button is usually located beneath the steering wheel. If you can’t locate it, check your owner’s manual. Inflate all of your tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to do the same thing to the spare tire, as it could also have a sensor.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment