How do you reset the transmission control module on a Dodge Durango?

How to Reset the Transmission Control Module on a Dodge Durango
To reset the Transmission Control Module (TCM) on a Dodge Durango, there are a few methods you can try based on the information from the search results:
1. Resetting TCM by Pulling Fuse F60:
– One method involves pulling the 15A fuse F60 and cycling the key to the “on” position. After this, the fuse is put back in place, effectively resetting the TCM.
2. Resetting TCM by Disconnecting the Battery:
– Another method involves disconnecting the negative battery terminal for more than 10 minutes. After reconnecting the battery and starting the car, the TCM should go into the re-learn process.
3. Resetting TCM by Resetting the PCM:
– The Powertrain Control Module (PCM) in the Dodge Durango can also be reset, which may indirectly reset the TCM. This involves removing the negative battery terminal, turning the ignition key to the “on/crank” position for 30 seconds, and then reconnecting the negative battery terminal.
4. Other Methods:
– There are other methods mentioned in the search results, such as draining the TCM by unplugging the battery or depressing the gas pedal while switching the ignition to the “on” position.
It’s important to note that these methods may vary based on the specific model year and trim level of the Dodge Durango, so it’s advisable to consult the vehicle’s manual or a certified mechanic for the most accurate instructions.

How do you reset a Dodge transmission control module?

Turn off your vehicle’s ignition and wait patiently for 5 to 10 seconds. Start the engine and allow it to idle for several seconds. Switch off the ignition and wait patiently for another 30 to 40 seconds. Repeat these steps 2 to 3 times in order to reset your vehicle’s transmission control module.

What are symptoms of a bad transmission control module?

Signs of a Bad Transmission Control Module

• Unpredictable shifting.
• Trouble shifting into higher gear.
• Trouble downshifting.
• Getting stuck in the same gear.
• Poor fuel economy.
• Check engine light comes on.

What are the steps to resetting transmission control module?

And hold it there for 10 to 20 seconds. While still pressing the pedal down turn off the ignition. Continue holding the gas down for 10 more seconds. Then slowly release the pedal.

What happens when you reset transmission control module?

Resetting the transmission control module could clear error codes. It makes the TCM forget everything it has previously learned. Some problems you could fix with a simple reset include delayed shifting, a stuck gear, and poor fuel economy.

Can you drive with a bad transmission control module?

You’ll want to get transmission control module problems squared away as soon as you start noticing symptoms like these because of how dangerous they can be to drive with.

Will a bad TCM throw a code?

In addition to supporting the transmission, the TCM may send OBD-II codes that alert you to any issues going on with the transmission. One common error to display is the check engine light.

Does a transmission control module need to be reprogrammed?

However, if the TCM itself is at fault, it may need replacement. After the problem has been conclusively diagnosed as a TCM issue, it can be installed easily enough. However, most TCMs will need to be programmed to the vehicle.

Does unplugging battery reset TCM?

Disconnecting a battery will not typically reset the transmission. While it may reset the vehicle’s computer systems, which could affect how the transmission operates, it does not directly reset the transmission itself [1].

How long does it take to reprogram a transmission control module?

If you take your vehicle to a repair shop that has the right tools and the information from the manufacturer, the process takes about 30 minutes to complete. Reprogramming a transmission shouldn’t take very long.

How do I manually reset my TCM?

And hold it there for 10 to 20 seconds. While still pressing the pedal down turn off the ignition. Continue holding the gas down for 10 more seconds. Then slowly release the pedal.