How do you reset the TPMS sensor on a Chevy Malibu?

How to Reset TPMS Sensor on a Chevy Malibu
To reset the TPMS (Tire Pressure Monitoring System) sensor on a Chevy Malibu, you can follow the reprogramming procedure outlined in the owner’s manual or use a TPMS activation tool. Here’s a step-by-step guide based on the information from the search results:
1. Check the DIC for Current Readings: Start by checking the Driver Information Center (DIC) for current tire pressure readings. This will help you identify which tire needs attention.
2. Reprogramming Procedure:
– Manual Reprogramming: If you have a keyless remote/key fob, you can reprogram the TPMS by holding in both the lock and unlock buttons at the same time until the horn beeps twice, indicating that it is ready to reprogram the TPMS.
– Using TPMS Activation Tool: Alternatively, you can use a TPMS activation tool to activate each sensor in the following order: LF, RF, RR, LR. Once a sensor has been activated, the horn will chirp and the right turn signal will be illuminated. Repeat this procedure for each tire, and once the LR has been activated, the horn will chirp twice, indicating the completion of the relearn process -TPMS-Reset-Procedure).
3. Adjusting Tire Pressure: After reprogramming the TPMS, adjust the tire pressure to the recommended levels as indicated in the Chevy Malibu user manual.
Remember to refer to the specific instructions in the owner’s manual for your Chevy Malibu model, as the reset process may vary depending on the year and model of the vehicle.
If you have any further questions or need additional assistance, feel free to ask!

How do you reset the tire pressure sensor on a Chevy?

And then the passenger side front. You go through all of them and it’ll reset your tire pressures. And tell the system which position each tire is in if you’ve rotated the tires recently.

How do you reset the service tire monitor system on a Chevy?

The Chevy “Service Tire Monitor System” Reset Process
The TPMS light and “service tire monitor system” warning can often be reset by adjusting your tire pressure to optimal levels and then driving around like you normally would for several minutes, followed by turning the car off, then back on.

Can I reset my TPMS myself?

Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait about 20 minutes for the sensor to refresh. You will find the tire pressure monitor reset button under the steering wheel. Refer to your vehicle’s owner’s manual if you can’t find it.

Where is the TPMS reset light?

Locate the TPMS reset button. It is typically located beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. Once you’ve found the TPMS reset button, press and hold it for approximately three seconds.

How do you relearn the TPMS on a 2018 Chevy Malibu?

Manual relearn procedure (2006-2020):

1. OBDII connector is not required.
2. Confirm TPMS sensors are properly installed.
3. Adjust tire pressures to placard value.
4. Turn ignition to ON.
5. Press and hold lock and unlock button on the key fob until horn sounds.
6. Activate TPMS Tool on left front tire sidewall next to valve stem.

How do I reset my Chevrolet TPMS?

After you inflate your tires, drive at 50 mph or above (in an appropriate speed zone) for 10 minutes to reset your sensor. The TPMS light should go away. Before you start your vehicle, turn your key to the “On” position. Once the TPMS light is on, hold the TPMS reset button until the icon flashes three times.

How do I manually reset my TPMS sensor?

Step the calibration. Process will finish automatically within a few miles of driving. See your vehicle’s owner’s manual for more details or go to owners.honda.com for a downloadable version.

Can you relearn TPMS sensors without a scan tool?

With the exception of some models that may be relearned to the vehicle via a driving procedure, a TPMS scan tool is required to complete the vehicle relearn procedure. Some aftermarket sensors require special programming to meet the vehicle’s application specifications prior to installation and relearn.

Where is the TPMS button located?

The TPMS reset button is usually located beneath the steering wheel. If you can’t locate it, check your owner’s manual. Inflate all of your tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to do the same thing to the spare tire, as it could also have a sensor.

How do I manually reset my TPMS light?

Between 30 and 60 miles per hour but not all at. Once.