AHG Auto Service » Make » Lexus » How do you reset the TPMS on a Lexus GS350?

How do you reset the TPMS on a Lexus GS350?

How to Reset TPMS on a Lexus GS350
To reset the Tire Pressure Monitoring System (TPMS) on a Lexus GS350, you can follow these steps:
1. Check tire pressure: First, ensure that all tires are properly inflated to the recommended PSI. This can be done by using a tire pressure gauge to measure the pressure in each tire. It is important to check the tire pressure when the tires are cold or when the vehicle has been sitting for a few hours.
2. Locate the TPMS reset button: On the Lexus GS350, the TPMS reset button is typically located on the instrument panel to the right of the steering wheel. However, it’s worth noting that some Lexus models may not have a physical reset button on the dashboard, and the reset process may need to be done using a scan tool.
3. Reset the TPMS: Once you have located the TPMS reset button, follow these steps:
– Turn the ignition to the “ON” position.
– Press and hold the TPMS reset button until you see the TPMS indicator light on the dashboard blink three times .
– Release the reset button.
4. Verify the reset: After performing the reset, the TPMS indicator light should stop blinking and remain off. This indicates that the TPMS has been successfully reset.
It’s important to note that if the TPMS light continues to stay on or if you encounter any difficulties during the reset process, it may be necessary to consult the vehicle’s owner’s manual or contact a Lexus dealership for further assistance.
Remember, maintaining proper tire pressure is crucial for optimal performance, fuel economy, and safety. Regularly checking and adjusting tire pressure is recommended to ensure the longevity of your tires and the safety of your vehicle.
I hope this helps! Let me know if you have any other questions.

How do you manually reset TPMS?

Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The tire pressure monitor reset button is typically located under the steering wheel. Refer to your vehicle’s owner’s manual if you’re unable to locate it.

Where is the TPMS module on a Lexus gs350?

The TPMS ECU is located in the driver’s c-pillar. You will need to remove the rear seat and the c-pillar trim to access it.

Where is the TPMS reset button on a Lexus GS 350?

Well. And right next to it there’s a button that says reset. So if you look at that. There. If you hold that button down. And look on the dash. You’ll see the tire. Light flash slowly.

What is the tire pressure for a 2017 Lexus GS 350?

Lexus GS Tyre Pressure
This tyre placard recommends a minimum tyre pressure of 36psi for the 2017 Lexus GS. This is equal to 250kPa and 2.5bar.

How do I clear my TPMS warning?

On press the home button on the touch. Screen then touch vehicle settings touch tpms calibration then select calibrate if calibration failed to start appears repeat the previous. Step the calibration.

Where is the TPMS reset button on a 2007 Lexus GS 350?

In earlier Lexus models with TPMS, there is a dedicated reset button usually located under the steering wheel, but consult the owner’s manual if you have a hard time finding it.

Where is the TPMS reset button located?

Set the parking brake. Look for a button to the left of the steering column labeled with the TPMS icon if it’s there push and hold it until the TPMS indicator in the instrument panel blinks twice.

What is the tire pressure for a Lexus GS 350?

This tyre placard recommends a minimum tyre pressure of 36psi for the Lexus GS. This is equal to 250kPa and 2.5bar.

How do I reset my Lexus TPMS?

With the vehicle off, turn the key to the “On” position, but don’t start the car. Hold down the TPMS reset button until the flashing tire pressure light blinks three times. Then release it. Ignite the engine and wait 20 minutes.

Can I reset my TPMS myself?

Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait about 20 minutes for the sensor to refresh. You will find the tire pressure monitor reset button under the steering wheel. Refer to your vehicle’s owner’s manual if you can’t find it.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment