How do you reset the TPMS on a Chevy HHR?

How to Reset the TPMS on a Chevy HHR
If the Tire Pressure Management System (TPMS) in the Chevy HHR is not working properly, you may have to reset the system. Here are the steps to re-initialize the TPMS:
1. Using a TPMS Reset Tool:
– Place the TPMS Reset Tool on the left-back tire wall near the air stem and activate it until the horn sounds. Repeat the steps if you are unable to reset the tire pressure warning light on the first try.
2. Without a Tool (2008-2011 Model Years):
– If you have a 2008-2011 Chevrolet HHR, you can reset the TPMS by increasing or decreasing the tire pressure without a tool. These instructions are based on the Chevy HHR owner’s manual.
3. Using the Vehicle’s Controls:
– Turn the ignition to the “ON” position without starting the vehicle and apply the parking brake. Then, hold down the tune/display button for 8 seconds until you see settings, press seek until you see “tire mon,” and press the 1 button until the reset message appears.
4. Using a TPMS Scan Tool:
– A TPMS tool, or another properly formatted TPMS scan tool, is required to perform this procedure. Starting with the LF tire, use the scan tool to scan each sensor in the following order: LF, RF, RR, and LR. The horn will chirp after the vehicle has received a signal from each sensor. After activating the LR tire, the horn will chirp twice, signifying the relearn is complete.
Remember, if you are still unsuccessful in resetting the TPMS, it’s advisable to contact the dealership for assistance or consult your vehicle’s user manual.

How do I manually reset my TPMS sensor?

Step the calibration. Process will finish automatically within a few miles of driving. See your vehicle’s owner’s manual for more details or go to owners.honda.com for a downloadable version.

Where is the tire light reset button?

Locate the TPMS reset button. It is typically located beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. Once you’ve found the TPMS reset button, press and hold it for approximately three seconds. You may need a pen or a similar tool to reach it.

How do you reset the tire monitor on a Chevy HHR?

1) Turn the ignition switch to the ON position. Apply the parking brake. 2) Press the “INFO” button on the DIC (see the appropriate figure), until the “TIRE LEARN” message is displayed on the DIC. Then press the “SET/RESET” button on the DIC, until a double horn chirp sounds, indicating the learn mode has been enabled.

How do you clear the service tire monitor on a Chevy?

Drive at or above 50 mph to reset the sensor for 10 minutes. This can cause your sensor to reset the next time you turn on the car. With the car off, turn the key to the “On” position, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times and then release it.

How do I turn off the TPMS light on my dashboard?

Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait about 20 minutes for the sensor to refresh. You will find the tire pressure monitor reset button under the steering wheel. Refer to your vehicle’s owner’s manual if you can’t find it.

Why is my TPMS light on but tires are fine?

TPMS malfunction: If the TPMS itself is malfunctioning, the light may come on even if your tire pressure is normal. If you see the tire pressure light and your tires seem properly inflated, it’s a good idea to have the TPMS checked by a mechanic.

Will my TPMS reset itself?

Once you’ve made your stop to fill your tires, the tire pressure light should reset itself automatically. Yet, if you still find the TPMS light on, there are a couple ways for how to reset the tire pressure light: Hop on the Brandon highway and drive at or above 50 mph.

Can I reset my TPMS myself?

Turn the car key to “on” but don’t start the vehicle. Press and hold the TPMS reset button until the tire pressure light blinks three times. Release the button and start the car. The light should go off within 20 minutes.

Where is the reset button on a Chevy TPMS?

The TPMS sensor should refresh within 20 minutes. The TPMS reset button is usually located underneath the steering wheel, but check your owner’s manual for its exact location.

Why wont my tire pressure light go off even though pressure is fine?

The causes can be a malfunction, or the weather changes. Other reasons why your TPMS light may still be blinking is because your tire may be damaged, or you might have gotten a recent tire replacement. Overall, the reasons can be vast, which is why it is best to take your car to a technician for professional diagnosis.