How do you reset the TPMS on a Acura CSX?

How to Reset TPMS on Acura CSX
To reset the TPMS (Tire Pressure Monitoring System) on an Acura CSX, you can follow these steps:
1. Check Tire Pressure: Ensure that all tires are inflated to the proper pressure as listed on the vehicle’s placard.
2. Drive the Vehicle: Operate the car for 20 minutes to reset the system. If your Acura has a TPMS reset button (for vehicles without a central display), it can often be found on the left or under the steering wheel. Check your Acura owner’s manual for assistance in locating the TPMS reset button.
3. Use a TPMS Scan Tool: If you have a properly formatted TPMS scan tool, you can use it to reset the TPMS light. With the engine running, scan each sensor again and drive the vehicle for 10 minutes above 30 mph to turn off the flashing TPMS light.
It’s important to note that if the TPMS light remains illuminated even after correcting the tire pressure problem, you will need to reset the TPMS using one of the suggested Acura TPMS reset procedures mentioned in the owner’s manual.
If you encounter any issues or are unsure about the process, it’s recommended to consult with an Acura service and parts center for assistance.

How do you resolve TPMS?

Drive at or above 50 mph to reset the sensor for 10 minutes. This causes your sensor to reset the next time you turn on your car. With the vehicle off, turn the key to the “On” position, but do not start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it.

How do you manually reset TPMS?

Set the parking brake. Look for a button to the left of the steering column labeled with the TPMS icon if it’s there push and hold it until the TPMS indicator in the instrument panel blinks twice.

What is the TPMS light on my Acura CSX?

Any time that the TPMS warning light comes ON, there is a possible low tire pressure condition.

How do you turn off the TPMS light on a Acura?

Turn the key to “On” (one position to the right), but don’t start the car. Now hold down the “TPMS Reset” button until the flashing tire pressure light blinks three times. Start the engine and wait 20 minutes. Check your owner’s manual if you have trouble finding the reset button.

Where is the TPMS button located?

The TPMS reset button is usually located beneath the steering wheel. If you can’t locate it, check your owner’s manual. Inflate all of your tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to do the same thing to the spare tire, as it could also have a sensor.

Why won t my tire pressure light go off even though pressure is fine?

If the light remains on after adjusting the tire to the proper PSI, you may need to repair your tire, have your TPMS inspected, or try one of the following: Go for a 10-minute drive. Get up to 50 MPH, if possible. Your vehicle may be equipped with a TPMS reset button or reset procedure in your vehicle control center.

Where is the Acura TPMS reset button?

Knowing how to reset a tire pressure light is often as easy as checking beneath your steering wheel. Your TPMS reset button will be underneath the steering wheel in your Acura, and pressing down on this button for a few seconds should reset the tire pressure light.

What is the TPMS system error on Acura?

Step 1 – Check your tires
You may actually have a tire that is low. Of course, the most obvious reason your Tire Pressure Monitor System (TPMS) is showing a warning is because one or more tires is under-inflated.

Where is my TPMS located?

The tire pressure sensor is typically found within the tire itself, mounted on the wheel assembly. These sensors relay crucial information to the vehicle’s computer, triggering the tire pressure sensor light when a discrepancy is detected.

Where is TPMS reset button?

Set the parking brake. Look for a button to the left of the steering column labeled with the TPMS icon if it’s there push and hold it until the TPMS indicator in the instrument panel blinks twice.