How to Reset the TPMS on a 2011 Chevy Aveo
To reset the TPMS (Tire Pressure Monitoring System) on a 2011 Chevy Aveo, you can follow these steps:
1. Turn the ignition to the “ON” position without starting the vehicle.
2. Locate the TPMS button, which is usually found underneath the left side of the dashboard.
3. Press and hold the TPMS button until you see the low tire pressure light blink several times.
4. Release the button.
5. Start your vehicle and let it run for at least 20 minutes.
6. The TPMS system should now be reset.
It’s important to note that the TPMS button may vary in location depending on the specific model and trim level of your Chevy Aveo. If you’re having trouble locating the button, you can refer to your vehicle’s owner’s manual for more specific instructions.
Please keep in mind that if the TPMS light continues to stay on after performing the reset, it may indicate a problem with the system or a tire that is still under-inflated. In such cases, it’s recommended to have your vehicle inspected by a qualified technician.
I hope this helps! Let me know if you have any other questions.
Source:
–
Contents
- Where is the TPMS reset located?
- How do you reset the TPMS on a Chevy Aveo?
- Can I reset my TPMS myself?
- How do you manually reset TPMS?
- Can you relearn TPMS sensors without a scan tool?
- Where is the reset button on a Chevy TPMS?
- Where is the reset button on the TPMS light?
- How do I manually reset my TPMS sensor?
Where is the TPMS reset located?
It is typically located beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. Once you’ve found the TPMS reset button, press and hold it for approximately three seconds.
How do you reset the TPMS on a Chevy Aveo?
Turn your car off, and then turn the key to the “On” position without starting the car. Hold down the TPMS reset button until you see the tire pressure light blink three times. Then, release the button.
Can I reset my TPMS myself?
Turn the car key to “on” but don’t start the vehicle. Press and hold the TPMS reset button until the tire pressure light blinks three times. Release the button and start the car. The light should go off within 20 minutes.
How do you manually reset TPMS?
Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait about 20 minutes for the sensor to refresh.
Can you relearn TPMS sensors without a scan tool?
With the exception of some models that may be relearned to the vehicle via a driving procedure, a TPMS scan tool is required to complete the vehicle relearn procedure. Some aftermarket sensors require special programming to meet the vehicle’s application specifications prior to installation and relearn.
The TPMS sensor should refresh within 20 minutes. The TPMS reset button is usually located underneath the steering wheel, but check your owner’s manual for its exact location.
Between 30 and 60 miles per hour but not all at. Once.
How do I manually reset my TPMS sensor?
Step the calibration. Process will finish automatically within a few miles of driving. See your vehicle’s owner’s manual for more details or go to owners.honda.com for a downloadable version.
