How do you reset the TPMS on a 2007 Ford Explorer Sport Trac?

Resetting TPMS on a 2007 Ford Explorer Sport Trac
To reset the TPMS (Tire Pressure Monitoring System) on a 2007 Ford Explorer Sport Trac, you can follow the steps below:
1. Type of TPMS System: The Ford Explorer uses a direct TPMS system, which means TPMS sensors are installed in the wheel. If one or more tires indicate low tire pressure, the TPMS sensors will transfer the information to the vehicle’s ECU. An indicator light or each tire pressure will show on the dash. When one or more sensors are replaced in a Ford Explorer, a TPMS relearn is recommended to write the IDs to the vehicle’s ECU to turn the TPMS light off. The type of TPMS system is direct, and the tire pressure is communicated via radio frequency (RF) technology from the sensor to the vehicle’s ECU.
2. Reset Procedure:
– Apply OBD module to DLC
– Turn ignition to ON
– Press OK on TPMS tool to transfer data to ECU
– Disconnect OBD module from DLC.
3. Additional Reset Procedure:
– Press and release the brake pedal.
– Turn the ignition to the OFF position.
– Cycle the ignition from OFF to RUN position 3 times, ending in the RUN position.
– The horn will sound once and the TPMS telltale will blink once train mode is initiated. If equipped with a message center, it will display “TRAIN LF TIRE.”
– Power off by pushing the button 1 time.
– Repeat 2 more times, ending in ACC mode.
– The horn will sound once and the TPMS telltale will blink once train mode is initiated.
– Starting at LF tire, decrease air pressure until the horn chirps. Repeat the procedure for the remaining tires in the following order: RF, RR, and LR -TPMS-Reset-Procedure).
4. Tools Needed: You will need a TPMS scan tool for this car model.
These steps should help you reset the TPMS on your 2007 Ford Explorer Sport Trac.

How do you manually turn off TPMS light?

Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait about 20 minutes for the sensor to refresh. You will find the tire pressure monitor reset button under the steering wheel. Refer to your vehicle’s owner’s manual if you can’t find it.

How do you relearn a Ford tire sensor?

When the vehicle is off, turn the key to the “On” position, but don’t start the car. Hold down the TPMS reset button until the light blinks three times, then let go. Start the car and give the vehicle about 20 minutes for the sensor to reset. Generally, you’ll find the reset button under the steering wheel.

How do you reset the TPMS on a 2007 Ford Explorer?

1) Turn the ignition switch to the OFF position, then press and release the brake pedal. 2) Turn the ignition switch from the OFF position to the RUN position three times, ending in the RUN position. Do not wait more than one minute between each key cycle. 3) Press and release the brake pedal.

Can I reset my TPMS myself?

Turn the car key to “on” but don’t start the vehicle. Press and hold the TPMS reset button until the tire pressure light blinks three times. Release the button and start the car. The light should go off within 20 minutes.

How do you turn off the TPMS light on a Ford Explorer?

Resetting Your Tire Pressure Light
Attempt to reset the TPMS sensor by driving at least 50 mph for 10 minutes. The next time you turn the car on, the light should be off.

How do I manually reset my Ford TPMS?

And this procedure. Works just fine for that car as it does this car. So this is an automatic ford escape 2013 push button start.

Where is TPMS reset button?

Set the parking brake. Look for a button to the left of the steering column labeled with the TPMS icon if it’s there push and hold it until the TPMS indicator in the instrument panel blinks twice.

Where is the TPMS switch located?

It is typically located beneath the steering wheel, near the driver’s sidekick panel, or on the dashboard. Once you’ve found the TPMS reset button, press and hold it for approximately three seconds.

How do you reset the TPMS on a Ford without the tool?

No need to go and buy the TPMS programming tool!

1. Make sure your tires are inflated to the recommended psi.
2. Turn ignition to the on position.
3. Push the hazard light button 6 times.
4. Release air pressure in the front left tire until you hear the horn honk.

How do I clear TPMS?

Turn the car key to “on” but don’t start the vehicle. Press and hold the TPMS reset button until the tire pressure light blinks three times. Release the button and start the car. The light should go off within 20 minutes.