How do you reset the oil life on a 2009 Chevy HHR?

Resetting the Oil Life on a 2009 Chevy HHR
To reset the oil life on a 2009 Chevy HHR, you can follow the steps below:
1. Using the Driver Information Center (DIC):
– Turn the key to IGNITION ON (no engine start).
– Press the information and reset buttons on the Driver Information Center (DIC) at the same time to enter the personalization menu.
– Press the information button to scroll through the available personalization menu modes until the DIC display shows OIL-LIFE RESET.
– If the light or message comes back on when you start the vehicle, the OIL LIFE SYSTEM has not reset. Repeat the procedure.
2. Using the Gas/Accelerator Pedal:
– Turn the car to the run position.
– Press the Gas/Accelerator pedal down and let it off three times within five seconds, and that will reset once you restart.
3. Using the Controls on the Left Side of the Steering Wheel:
– Turn the key to the ON position. Do NOT start the ignition.
– Using the controls on the LEFT side of the steering wheel, press the THIRD button until OIL LIFE reads on the dashboard screen. Release them when you see OIL LIFE RESET.
These methods should help you reset the oil life on your 2009 Chevy HHR.

How do I reset my oil life manually?

First, turn your key to the “On” position (which is two turns of the key). Make sure to not start the engine. Completely press down the gas pedal three times within ten seconds, then turn off your vehicle. Start up the vehicle to check that your oil light has reset.

How do I reset my oil life to 100%?

Once it starts to Blink you’ve released a button for a moment. And then you press it and you hold it back in again. And it’ll reset to 100 and it’ll stop blinking that’s it reset.

Do you have to reset after oil change?

Every time you get your car’s oil changed, it’s important to reset the oil change indicator light on your dashboard. If you don’t reset the indicator, you may find that your car will indicate that you need another oil change far sooner than it should.

How do you reset the oil life sensor?

The oil pressure sensor can be a useful troubleshooting. Step if you’re experiencing abnormal readings or warning lights on your car’s dashboard. However.

Do you have to manually reset oil life?

Every time you get your car’s oil changed, it’s important to reset the oil change indicator light on your dashboard. If you don’t reset the indicator, you may find that your car will indicate that you need another oil change far sooner than it should.

How do you reset the check engine light on a Chevy HHR?

Steps to Reset Check Engine Light

1. Turn off the ignition and put on safety glasses and gloves.
2. Locate the negative terminal on your car battery.
3. Loosen the nut on the negative terminal with a wrench and pull the negative connector from the battery.
4. Reconnect the negative cable and tighten it with your wrench.

How do you reset the transmission control module on a Chevy HHR?

And hold it there for 10 to 20 seconds. While still pressing the pedal down turn off the ignition. Continue holding the gas down for 10 more seconds. Then slowly release the pedal.

How do I reset my Chevy HHR?

We go to the on position. We hit the gas pedal three times all the way to the bottom. I. Didn’t actually did it four times. Then. I go back. There goes reset so there goes that plain.

How do you reset the oil life on a 2009 Chevy?

Off. Let’s turn the key back on. And as you can see the change oil soon light is no longer displaying. Just the uh.

How do you reset the oil life after an oil change?

To reset your oil light, simply pump your gas pedal down to the floor 3 times, pausing briefly between each pump. Depending on your car’s model and year, you might see a message on your dash telling you the light is reset.