How do you remove the drive belt on a Ford Ranger?

Removing the Drive Belt on a Ford Ranger
To remove the drive belt on a Ford Ranger, you can follow these general steps:
1. Locate the Tensioner Pulley: The tensioner pulley is used to relieve tension on the drive belt, allowing for its removal.
2. Use a Tensioner Tool or Wrench: You can use a 3/8 inch drive wrench or a tensioner tool to rotate the tensioner pulley bolt and release the tension on the serpentine belt.
3. Remove the Belt: Once the tension is released, you can slip the belt off the pulleys.
4. Replace the Belt: After removing the old belt, you can install the new belt by following the reverse procedure, ensuring it is routed properly and the tensioner is working correctly.
It’s important to consult the specific manual for your Ford Ranger model for detailed instructions tailored to your vehicle.
If you have any specific questions or need further assistance, feel free to ask!

How do you remove a drive belt tensioner pulley?

And then I just pulled the belt off the idler pulley now with my ratchet. 15 millimeter again I’m gonna go that same boat that I just pulled to get the belt loose. I’m gonna go and loosen.

How many belts does a Ford Ranger have?

Most Ford Ranger’s have 1 or 2 drive belts and in some instances, it may be called a serpentine belt. The belt needs to be flexible to circulate across pulleys and can be made out of perishable compositions like rubber, neoprene or urethane.

How to change a belt on a Ford Ranger?

Body to lock it in the retracted. Position the outer hole is to the right of the square hole for the breaker bar or ratchet.

How do you change a drive belt yourself?

Steps

1. Loosen Tension And Remove Belt. Locate the adjustment fastener and loosen it.
2. Inspect Drive And Drive Pulleys. Check the drive and pulley wheels.
3. Select Correct Replacement Belt.
4. Install New Belt.
5. Correctly Tension New Belt.
6. Start The Engine.

How do you loosen an idler pulley?

Off. You could either use a 5/8 socket or a 15 millimeter. Socket. So here’s the pulley just take the dust shield off in the back. A lot of times a bad pulley will make noise when you do this.

How long does it take to replace a drive belt?

Plus, replacement is relatively easy, and if you’re wondering how long does serpentine belt service take, it’s less than an hour for most vehicles.

How do you release tension from a spring loaded tensioner?

Simply place a box-end wrench on the bolt head or the nut and pull the idler back so you can align belt . The nut should be tight enough to relieve tension without loosening up on you . I roll the belt off and on all spring loaded idler arms, Much easier than fighting a spring off and on…..

Is replacing a drive belt hard?

Serpentine belt replacement is easy because today’s automatic drive belt tensioners eliminate the need to loosen bolts or pry components into position for retensioning. Just rotate the tensioner, remove the old belt and install a new one.

How do you release the tension on a drive belt?

I’m going to stick it right. There. And then basically you’re just going to go ahead and pull down. And you can see that the belt gets loose. Okay pulling down belt gets loose.

How much does it cost to replace a serpentine belt on a Ford Ranger?

The average cost for Ford Ranger Serpentine Belt Replacement is $117.