How do you remove a Subaru crank pulley?

Removing a Subaru Crank Pulley
To remove a Subaru crank pulley, you can follow these steps:
1. Prepare the vehicle: Park the vehicle on a level surface and engage the parking brake. Open the hood and locate the crank pulley at the front of the engine.
2. Remove the drive belts: Loosen the tension on the drive belts by using a wrench or socket to turn the tensioner pulley. Once the tension is released, slip the belts off the pulleys.
3. Secure the crank pulley: Use a crank pulley holder tool or a breaker bar to secure the crank pulley in place. This will prevent the pulley from rotating while you loosen the bolt.
4. Loosen the crank pulley bolt: Use a socket and breaker bar or an impact wrench to loosen the crank pulley bolt. Apply steady pressure in the counterclockwise direction to loosen the bolt. Note that the bolt may be tight and require significant force to loosen.
5. Remove the crank pulley: Once the bolt is loosened, you can remove the crank pulley by hand. If it is stuck, you can gently tap it with a rubber mallet to loosen it.
It’s important to note that some Subaru models may require specific tools or techniques for crank pulley removal. If you are unsure or uncomfortable performing this task, it is recommended to consult a professional mechanic or refer to the vehicle’s service manual for detailed instructions.
Please keep in mind that the information provided above is a general guide and may not apply to all Subaru models. It’s always best to consult the specific instructions for your vehicle.

What are the symptoms of a bad crankshaft pulley?

Symptoms such as a loss or change in vehicle performance, knocking or more vibration than normal from the engine bay and even metallic tapping as engine parts slip out of sync are all very clear while the engine is idling or under load during use.

Are crank pulley reverse threaded?

It is right handed threads, so you need to turn it to the left to loosen (left if looking at the front of the pulley bolt).

Which side of crank is reverse thread?

And the cup on the left side is a normal thread pedals by the way are the opposite. So if you’re going to remove a pedal the right pedal is a normal thread. And the left pedal is a reverse thread so

Which way do you remove a crankshaft pulley bolt?

Still with the engine rotating clockwise. Actually removes the bolt by turning it counterclockwise. With the fuel fuse removed you’re going to turn the key to run for a second then. Off.

Can you move a crankshaft pulley by hand?

Not when the engine is fully assembled. The only pulleys you should be able to turn by hand when the serpentine belt is not in place are: the water pump, alternator, and power steering pump pulleys.That you cannot rotate either cam or crankshaft pulleys by hand is completely normal.

How do you remove a stubborn crank pulley bolt?

And we’re going to loosen it up. And it’s that easy that belt will pinch upon itself. And that provides the grip. So that you can put any amount of torque on the fastener.

What tool removes crankshaft pulley?

But in general you need a ‘harmonic balancer removal/install tool‘. Also commonly referred to as a ‘crank pulley tool’.

How do you remove a crankshaft pulley?

So when I put my key in the ignition. And turn it it’ll loosen the bolt. And now as you can see. I can just take the bolt off by hand. And out it comes.

Which way do you turn the crankshaft pulley bolt?

Side because the engine rotates clockwise the concept is that holding the bolt. Still with the engine rotating clockwise. Actually removes the bolt by turning it counterclockwise.

Can I drive with a bad crankshaft pulley?

If that happens, all components that derive power from that belt will stop functioning.So, how long can you drive with a bad idler pulley? The safety recommendation is not to drive the car at all and take it to a mechanic immediately.