How do you remove a Ford fuel line clip?

To remove a Ford fuel line clip, you can follow these steps:
Using a Specialty Tool:
1. Access the head of the clip in the side of the fuel line end housing.
2. Place the tip of the fuel line removal tool around the head of the clip and release the clip, then carefully pull the fuel line away from the filter.
Without a Specialty Tool:
1. Place the tip of a pocket screwdriver between the head of the clip and the fuel line end housing.
2. Carefully release the clip and pull the fuel line away from the filter.
It’s important to note that a special tool is available from Ford and other manufacturers for removing the retaining clips. The tool is Ford Tool T90T-9550-B or C, or equivalent. If the tool is not on hand, a pocket screwdriver can be used as an alternative, but caution and patience are required to avoid damaging the clip or the fuel line.
I hope this helps! If you have any other questions, feel free to ask.

How do you remove a herbie clip?

To remove the clip, place the HCL removal tool at the bottom part of the female jaw and slide or twist sideways. The Herbie Clip is very simple to fit.

How do you remove poly pipe pinch clamps?

And just bend it backwards. And it comes right. Off just take that little tab you bend up with the side cuts grab hold of it with the channel lock bend it back. Comes right off. Pretty easy.

How do you release a Ford fuel line clip?

We remove these quickly uh you pull out on this tab push in on this push. Down pull off that’s going to pull out push in push down pull out really that simple going back on we push. On we lock.

How do you install Ford fuel line clips?

So what I’m going to do is put a brand new one in now. And as you can see. This is a new one. Okay that’s the old one. And all we’re going to do is see this inside the top of there.

How do you remove a fuel filter clip?

That clip all the way in and that’s secure now we’re going to pop the fuel filter into its clip. And then we’ll connect these two fuel lines. And we’re done the top one is the bigger hose.

What size is the fuel line disconnect tool on a Ford f150?

5/16 x 3/8
CTA Tools 1810 Ford Fuel Line Disconnect Tool – 5/16 x 3/8.

How do you remove quick connect fuel lines?

Today. With the push type connector. There are a couple different versions as you can see on this connector. There is a push here. And location the push on the other side.

How to make a fuel line release tool?

Well is to take bicycle handlebar and cap. And all you do is cut a notch out of it using a dremel and then obviously cut the tabs there cut the tab. As well. And kind of shave down each of the tabs.

How do you remove fuel line clamps?

Now in this scenario. Here I don’t actually have the correct tool and they are a specialty tool. I can either use a set of bull nose cutters or you can use a set of side cutters. Now.

How do you remove a stuck fuel line connector?

And working the line back and forth. You may need to use pliers to help push the disconnect. Tool into the connection. If the connection is too rusty the rust.