How do you put Ford Fusion brakes in service mode?

Putting Ford Fusion Brakes in Service Mode
To put the Ford Fusion brakes in service mode, you can follow the steps below:
1. Insert the key into the ignition switch and turn it to the accessories position.
2. Press on the brake pedal and set the gear shift to neutral.
3. Press and hold the accelerator pedal and the parking brake button together.
4. The electronic parking brake system will be deactivated, preventing parking brake application until service has been completed and maintenance mode has been deactivated. The yellow electronic parking brake indicator will be illuminated, and maintenance mode will display on the message center .
When replacing rear brake pads in maintenance mode, the brake caliper piston must be compressed into the caliper housing. The brake caliper piston does not have to be rotated while compressing the piston. After the maintenance is completed, carry out the service mode deactivation procedure to activate the electronic parking brake system.
It’s important to note that these steps are specifically for 2013 and newer Ford Fusion models with rear calipers using electric motors to actuate the electronic parking brake. Always refer to the specific model’s manual for accurate instructions.
If you have any further questions or need additional assistance, feel free to ask!

How do you put a 2015 Ford Fusion in brake service mode?

At. The same time you’re gonna hold the accelerator pedal down to the floor. So you’re gonna hold them both down like this. And what you’re gonna do.

What happens if you dont put brakes in service mode?

If you did not put it in service mode then you will need to use a specialized scan tool to reset the system. Typically when this happens it will damage the parking brake actuators and they will have to be replaced.

How do you put a Ford Electronic parking brake in service mode?

And you’re going to hold it for a few seconds. I think five seconds. While you’re holding them both throttle to the floor button push down turn the ignition off wait a few seconds. Turn it back on.

How do you put a Ford Fusion in brake maintenance mode?

So push it once and then within five seconds push it again. I can hear it re-engaging there in the. Back. Let’s make a whole bunch of noises back there. And now it is disengaged.

How do you put Ford brakes in service mode?

Press the gas pedal all the way to the floor, press the electronic parking brake switch and ignition switch at the same time and while holding the gas pedal and switch down, cycle the ignition switch on and off twice.

How do you turn off park brake maintenance mode on a Ford Fusion?

These are the steps that need to be followed exactly to deactivate maintenance mode.

1. Set the ignition to ON. (
2. Press and hold the accelerator pedal.
3. Place the EPB switch in the APPLY (upward) position.
4. Firmly press the brake pedal for at least 1 second.

How do you engage brake service mode?

So we wait till that flashes when that flashes. We want to release our foot off the brake pedal right there. And push it one more time. Now you can hear it doing its. Thing. There we go.

How to put 2017 Ford F 150 in maintance mode to service rear brakes?

Turn it on then you push your gas pedal all the way to the floor. Then hold down on your parking brake switch. Then you turn the key off. And then back on within five seconds.

How to put a 2016 Ford Fusion all wheel drive SE into service mode push button start?

Position. So you’re going to hear it in the back. Retracting brake lights flashing. Here in a second it should pop up there it is park brake maintenance mode wait till it’s done release.

Do I need to put my car in service mode for brakes?

This mainly depends on the manufacturer of the EPB, and the availability of a capable scan tool (if required) to enter the “service mode”, which most EPBs require before any work can be done on the brake(s) affected.