How do you put coolant in a 2008 Chevy Cobalt?

Adding Coolant to a 2008 Chevy Cobalt
Adding coolant to a 2008 Chevrolet Cobalt is a relatively straightforward process. Here’s how you can do it:
1. Locate the Coolant Reservoir: The coolant reservoir in your Cobalt is located in a specific area. It’s important to check your engine when it is cold for an accurate reading. The video above shows you where the coolant reservoir in your Cobalt is located and how to add coolant/antifreeze /coolant_antifreeze/add_coolant).
2. Check the Owner’s Manual for the Correct Type of Fluid: It’s essential to check your owner’s manual to determine the correct type of fluid to add. For Chevrolets, this information is typically found in a section titled “Fluid Capacities” in the back of the manual /coolant_antifreeze/add_coolant).
3. Use the Correct Coolant: The 2008 Chevy Cobalt uses DEX-COOL extended life radiator coolant and cannot be mixed with regular green antifreeze radiator coolant, as it will form an acid that is damaging to the cooling system.
4. Add Coolant Carefully: When adding coolant, make sure to pour it in slowly and steadily. Be mindful of the “COLD FILL” line on the reservoir to avoid overfilling.
5. Run the Car to Remove Air Pockets: After adding coolant, it’s recommended to run the car until the cooling fan kicks on and the air is sucked out of the line. This may require adding more coolant after the air pockets are removed.
Remember to always follow the specific guidelines outlined in the owner’s manual for the 2008 Chevy Cobalt to ensure the correct type and amount of coolant is added.

What kind of coolant does a 2008 Chevy Cobalt take?

Prestone Universal Yellow Antifreeze and Coolant Concentrate
Notes: Extended life, Full strength concentrate.

Is it okay to put any type of coolant?

What Coolant Does Your Car Need? Different vehicles require different coolants. There are varieties for every type of vehicle, from diesel engines to American, Asian and European vehicles. Each one is specifically formulated to keep its designated engine type running in extreme temperatures.

Where does coolant go in a 2008 Chevy Cobalt?

The surge tank until it meets the minimum water level and be careful not to overfill the tank. Alternatively. You can buy premix radiator coolant at your dealership.

Do I put coolant in the radiator or reservoir?

Remove the cap completely. If the coolant level is low, add the correct coolant to the reservoir (not the radiator itself). You can use diluted coolant by itself, or a 50/50 mixture of concentrated coolant and distilled water. When coolant rises to the cold fill line, replace cap and tighten it until you feel it click.

What color coolant for Chevy Cobalt?

Prestone® DEX-COOL® (orange) antifreeze+coolant (AFC) is specially designed to work with All GM® vehicles 1995 & newer; ‘GM approved formula’ (GMC, Chevrolet, Buick, Cadillac, Pontiac, Saturn, Oldsmobile, Hummer), most Ford® vehicles 2011 – 2018 (Ford, Lincoln, Mercury) and most FCA® vehicles 2013 & newer (Ram, Dodge, …

What to do after putting coolant in car?

Once the coolant has been added, start the engine and allow the system to run with the heater on high. If the temperature light comes on or there is no warm air from the heater, you should call in a professional as something may have gone wrong.

Is coolant and antifreeze the same thing?

Key Takeaways:
Coolant is a fluid used in the radiator to remove the engine’s heat. Antifreeze is an additive mixed with water or coolant to prevent your car engine from freezing in cold weather. The ratio of water or coolant to antifreeze should be 50:50.

Does the car need to be running when adding coolant?

Never add coolant to a vehicle unless the engine is off, and the temperature of the coolant has dropped considerably. Otherwise, if you take off the radiator/coolant reservoir cap, you may scald yourself with freshly boiling coolant.

What coolant does a Chevy Cobalt take?

Prestone® DEX-COOL® (orange) antifreeze+coolant (AFC) is specially designed to work with All GM® vehicles 1995 & newer; ‘GM approved formula’ (GMC, Chevrolet, Buick, Cadillac, Pontiac, Saturn, Oldsmobile, Hummer), most Ford® vehicles 2011 – 2018 (Ford, Lincoln, Mercury) and most FCA® vehicles 2013 & newer (Ram, Dodge, …

Will radiator pull coolant from reservoir?

As the warmth rises, coolant expands and overflows into the coolant reservoir and is then sucked back into the radiator as your car cools down after shut-off.