How do you jack up a Subaru Impreza?

How to Jack Up a Subaru Impreza
To safely jack up a Subaru Impreza, it is important to locate the proper jack points. Here are the steps to jack up a Subaru Impreza:
1. Use a floor jack: Start by using a floor jack to lift the car. It is important to use a floor jack that is appropriate for the weight of the vehicle.
2. Locate the front jacking point: Slide the jack under the front end of the car and find the front jacking plate. This is located behind the oil pan.
3. Locate the rear jacking point: The traditional rear jacking point for most Subaru vehicles is directly under the rear differential.
4. Use jack stands: Once the car is lifted, it is recommended to use jack stands to support the vehicle. However, it is important to note that the pinch welds are not recommended for jack stand placement as it may bend the pinch welds.
It is always a good idea to consult the owner’s manual for specific instructions on jacking up your Subaru Impreza. Additionally, using a rubber pad or a hockey puck on the jack can help protect the vehicle’s undercarriage.
Please note that these instructions are general guidelines and it is important to exercise caution and follow proper safety procedures when working on a vehicle.

Where do I put the jack under my car?

Locate the jack point on the vehicle
Your owner’s manual should give you the location of jack points. Usually there’s one on each side behind the front wheels and in front of the back wheels, close to the rocker panels. There may be central jack points located behind the bumpers (front and rear).

How do you jack up a 2013 Subaru Impreza?

Pan. Okay and right on those back two bolts. So I’m gonna put it up on. So the two bolts are like sitting in the middle of the jack. That circle pad.

How do you lift a Subaru with a jack?

Finally place the jack stands under the pinch welds. And lower the floor jack ing up the car from the back can be done in a pretty similar way just like the last time we’ll be chalking off our Wheels.

Where to place jack Subaru crosstrek?

Right here in the frame rail there’s a couple notches. On both sides. That’s right where you want to put your jack stands and that’s how you do the rear of the car.

Where do you put the jack stands when jacking up a car?

Place the jack stand under the car frame at reinforced point or “pinch weld” near where the jack is placed. Pin-type jack stands use locking pins to adjust the height, while screw-type jack stands use adjustable screws.

Is it bad to leave a jack under a car?

Can you leave a jack under a car? Yes, but better to leave it in the boot. Seriously, you can, but better to put something solid in the right place as well in case the jack failed. Don’t ever put any part of yourself under a jacked up vehicle.

Where is the jack point on a Subaru?

So that’s a good indicator that’s where you put the jack. And the same in the front. On this pinch rail underneath where my jack is there’s little divots of metal.

Where to place jack for Subaru outback?

That’s going to be where your jack point is they recommend you put it right here alternatively. If you go a little bit further on the inside.

How do you jack up a 2017 Subaru Impreza?

Pan. Okay and right on those back two bolts. So I’m gonna put it up on. So the two bolts are like sitting in the middle of the jack. That circle pad.

Where to place jack subaru impreza?

The easiest and best location will be the rear differential. If your jack has a metal plate on it I would highly recommend using a piece of wood to not chip or damage the diff. Using a piece of wood helps keep the rear diff from chipping or damage when lifting it.