How do you drain the coolant on a 2008 Lexus RX 350?

To drain the coolant on a 2008 Lexus RX 350, you will need to follow a few steps. Here is a general procedure based on the search results:
1. Gather the necessary materials:
– Coolant/antifreeze
– Drain pan
– Safety goggles
2. Locate the coolant reservoir:
– The coolant reservoir is typically located near the engine bay. You can refer to your owner’s manual or consult a Lexus service technician for the exact location.
3. Drain the coolant from the reservoir:
– Start by removing the coolant reservoir cap. Note: It is important to do this when the engine is cold to avoid any potential injuries.
– Place a drain pan underneath the reservoir to catch the coolant.
– Allow the coolant to drain completely from the reservoir.
4. Drain the coolant from the radiator:
– Locate the radiator drain plug or the lower radiator hose. The drain plug is usually located at the bottom of the radiator.
– Position the drain pan underneath the drain plug or hose.
– Open the drain plug or remove the lower radiator hose to allow the coolant to drain completely from the radiator.
5. Dispose of the old coolant properly:
– Coolant is toxic and harmful to the environment, so it should be disposed of according to local regulations. You can check with your local waste management facility for proper disposal methods.
Please note that the steps provided are a general guide and may vary depending on the specific model and configuration of your 2008 Lexus RX 350. It is always recommended to consult the owner’s manual or seek assistance from a qualified Lexus service technician for the most accurate instructions.
Source:
– Search result snippet from Source : ‘Learn how to flush the coolant (antifreeze) in your 2008 Lexus RX350. Coolant / antifreeze circulates through RX350 radiator and engine to maintain the proper temperature. Coolant / antifreeze also passes through the heater core under your cowl to provide heat to the cabin of your RX350. In addition to preventing your car from overheating, coolant / antifreeze also helps lubricate the seals in the water pump and hoses. Start your coolant flush by draining the coolant / antifreeze that is in your reservoir, then drain the coolant that is in your radiator by opening the petcock or removing the lower radiator hose.’

How do I drain my entire coolant system?

Locate the Drain Plug and Loosen
Locate the drain plug. This is found on the bottom of the radiator. Place a pan under the drain plug to catch old coolant. Loosen the drain plug and allow coolant to flow.

Where is my coolant drain plug?

Looking at the bottom of the radiator from underneath the vehicle, the drain plug is located at the center of the radiator body. It looks like screw-in stopper, and is slotted to accept a phillips head screwdriver.

How do you drain coolant without a drain plug?

In general, the easiest way to drain coolant from systems like these is to disconnect the lowest fitting between the coolant hose and the engine block and let the coolant just drain out. Usually, it’s near the bottom of the block itself, so it shouldn’t be hard to reach from underneath the vehicle.

How do you empty a coolant tank?

Remove the radiator or coolant reservoir cap under the bonnet, then unscrew the drain valve below. If you don’t have a drain valve, you will need to remove the bottom radiator hose. The coolant should begin to flow out into your container. Once it’s empty, close the drain valve or refit the hose.

Where is the engine coolant drain plug?

And changing the coolant on. This. Car the first stage in this process is to actually get the coolant. Out in most cars there’s a drain pipe or a tap on the back side of the radiator.

What kind of coolant does a Lexus RX350 take?

Pentosin – Pentofrost A4 HOAT Phosphated Asian 50/50 Prediluted Antifreeze / Coolant – 1 Gallon (Part No. 8115209)

Do you have to remove thermostat to flush coolant?

No, it is not necessary to remove the thermostat. In fact, some cars you don’t want to remove the thermostat while running the vehicle. The reason for this is that the thermostat can be used to direct coolant flow. If it is out, parts of the engine may not be getting coolant as designed.

How much is a coolant change for a Lexus RX350?

between $243 and $275
The average cost for a Lexus RX350 Coolant Change is between $243 and $275. Labor costs are estimated between $125 and $158 while parts are typically priced around $118. This range does not include taxes and fees, and does not factor in your unique location.

How often should you change coolant Lexus RX 350?

every 30,000 miles
How often should you change coolant in a Lexus RX 350? Typically, you should have your Lexus RX 350 coolant flush completed every 30,000 miles or every two years. There are some instances where your automobile can go without a flush for a longer period of time.

Does coolant have a drain plug?

Fall within place a container underneath the radiator. And loosen the drain plug.