AHG Auto Service » Make » Subaru » How do you disable the DRL on a Subaru Legacy?

How do you disable the DRL on a Subaru Legacy?

Disabling Daytime Running Lights (DRL) on a Subaru Legacy
To disable the Daytime Running Lights (DRL) on a Subaru Legacy, there are a few methods you can try. Please note that disabling the DRL may have legal implications in some regions, so it’s important to check local regulations before proceeding.
1. Pull the hand brake: On some Subaru models, including the Legacy, the DRLs will not come on if the hand brake is engaged, even just one notch.
2. Disconnect the DRL connector: Another method involves disconnecting the DRL connector. The location of the connector may vary depending on the model year and trim level of the Legacy. For example, on the 2015-2017 Outback, the DRL connector is located behind the driver’s side headlight. You can unplug the connector to disable the DRLs without removing the headlight or bumper.
3. Use a relay: Some users have reported success in disabling the DRLs by using a relay. This method involves splicing into specific wires and intercepting the DRL circuit. However, it’s important to note that this method may require more technical knowledge and could potentially void the vehicle’s warranty if not done correctly.
It’s worth mentioning that disabling the DRLs may have safety implications, as they are designed to increase visibility during dusk and dawn. Without the DRL safety feature, you may be at a higher risk for accidents.
Please keep in mind that these methods are suggestions found in online forums and may not be officially recommended by Subaru. It’s always a good idea to consult the vehicle’s manual or reach out to a certified Subaru technician for guidance specific to your model and year.
I hope this information helps! Let me know if you have any other questions.

Is it possible to turn off DRL?

This is especially helpful in the periods right after dawn and before sunset to increase visibility to other motorists. If your vehicle is equipped with a “DRL OFF” setting, they can be turned off by twisting the headlight control knob to “DRL OFF.”

What is a DRL switch?

Daytime running lamps (DRL, also daytime running lights) are lighting devices that are on the front of a vehicle. Thanks to smart Honda engineering, these automotive lights automatically switch once the vehicle is set to drive.

Where is the DRL sensor?

The DRL module is typically located at the front of the vehicle or near one of the headlights. It can also be found inside the vehicle’s dashboard, in one of its fenders, or behind the front bumper. The modules won’t look the same on every vehicle equipped with daytime running lights, so be careful.

Why are my daytime running lights not turning off?

You can set the parking brake to see if that shuts off the headlights, as setting the parking brake typically disables daytime running lights. Removing or replacing the daytime running light module will probably fix that problem.

What is the DRL button?

A daytime running lamp (DRL, also daytime running light) is an automotive lighting and bicycle lighting device on the front of a roadgoing motor vehicle or bicycle, automatically switched on when the vehicle’s handbrake has been pulled down, when the vehicle is in gear, or when the engine is started, emitting white, …

What controls daytime running lights?

DRLs operate all on their own. They illuminate when you engage the ignition and extinguish when the headlights activate. The driver has no real control over operating DRLs because there is no DRL on-off switch.

Why is my DRL light always on?

Faulty Light Switch: A malfunctioning light switch can cause the DRL to remain on even when the vehicle is turned off. The switch may be stuck in the “on” position, preventing it from properly disengaging the lights. In this case, the switch may need to be repaired or replaced.

Is it OK to drive with DRL light on?

But there are plenty of studies showing that some light is better than none. Driving with your DRLs or headlights on during the day reduces your risk of a crash in every country except the United States.

Where is the DRL module located?

You can usually find the daytime running light (DRL) module at the vehicle’s front or near one of the headlights.

Why is DRL showing on my dashboard?

The DRL warning light is a small lamp that is located on the dashboard of your car. It is usually illuminated when there is an issue with the vehicle’s daytime running lamps or other vital components of the car’s safety system.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment