How do you clear the code on a Ford f150?

How to Clear the Codes on a Ford F-150
To clear the codes on a Ford F-150, you can follow these steps:
1. Disconnect the negative battery terminal: Under the hood of your Ford F-150, use a hand wrench to loosen the black (negative) battery terminal clamp. Wiggle the clamp to remove it from the battery post.
2. Wait for a few minutes: Leave the battery disconnected for a few minutes to ensure that the vehicle’s computer system resets.
3. Reconnect the battery terminal: After waiting, reattach the black (negative) battery terminal clamp and tighten it securely.
By disconnecting and reconnecting the battery, you can reset the codes on the OBD II (On-Board Diagnostics II) computer of your Ford F-150.
Please note that this method is applicable to U.S. vehicles made prior to 1996, as those vehicles used OBD I computers. For newer vehicles, it is recommended to use an OBDII scanner to clear the codes.
I hope this helps! Let me know if you have any other questions.

How do I reset my Ford code?

First you’ll punch in the factory. Code which will unlock the vehicle. Quickly press the 1 2 button after the code and you’ll hear the vehicle. Lock.

How do you force clear the check engine light?

Then take a suitable socket or wrench loosen. Up the negative cable. And remove it from the battery’s post. Then go back inside the car and press the horn for half a minute or turn on the Headlights.

How do you turn off the check engine light on a Ford F 150?

Disconnect the Negative Battery Cable

1. Turn off the ignition and put on safety glasses and gloves.
2. Locate the negative terminal.
3. Loosen the nut on the negative terminal with a wrench, then pull the negative connector from the battery.
4. Reconnect the negative cable and tighten it back up with your wrench.

How many miles do you have to drive to clear a permanent code?

You cannot clear a permanent code with a scanner or battery disconnect. And this is the important part: Driven 200 miles and have 15 Warm Up cycles since the last time the DTC’s codes were cleared.

How do I reset my Ford system?

So will completely erase all information stored. On your sync 3 and sync connect system back to the factory default settings. Including all of your paired Bluetooth devices.

How do I reset my Ford f150?

Performing a System Reset
Vehicles equipped with a Power button: Press and hold both the Power button (center of the volume knob) and the Seek Right button for 10 seconds.

How do I clear permanent codes on my f150?

The only way to clear a PDTC is to fix the underlying problem with the vehicle that originally caused the PDTC and its corresponding DTC to set, and then allow the vehicle sufficient drive time to re-run the monitor that identified the problem in the first place.

How do you clear check engine codes?

Plug an OBD-II scanner into your vehicle’s OBD port and reset it to clear the check engine light. Disconnecting and reconnecting your battery will restart your vehicle’s computer and clear the light. Drive an older vehicle around for a few days after repairs. The light will go off on its own once the computer resets.

Can I clear check engine light myself?

While a code reader is usually the most immediate way of resetting a check engine light, there are a few alternative methods you could try: Temporarily disconnect the battery; start by locating the negative terminal and disconnecting it, then repeat with the positive terminal.

How do I manually turn off my check engine light?

The easiest way to reset a check engine light is to disconnect the negative (black/-) battery cable and hold it to the side for 30 to 60 seconds. This will allow your internal diagnostics systems to reset.