How do you change the wiper blades on a 2009 Acura TSX?

Changing Wiper Blades on a 2009 Acura TSX
To change the wiper blades on a 2009 Acura TSX, follow these steps:
1. Purchase the Correct Wiper Blades:
– Ensure you purchase the correct size blades for your TSX. The driver side wiper blade is typically larger than the passenger side blade, so be sure to get the correct size blades for your vehicle.
2. Remove the Old Wiper Blades:
– Turn on your wipers and then turn off your Acura TSX when the wipers are at their mid-way point on your windshield. Lift your wipers up and away from your windshield. The old wipers should stick out, away, from your windshield, allowing for easy access during the changing process.
3. Install the New Wiper Blades:
– Position the new blade so that the hook is pointing at the wiper attachment. The hook will go over the top of the attachment. Pull the blade toward the end of the arm. You’ll hear a click when it locks into position. Repeat the process on the passenger side of your TSX.
4. Additional Tips:
– Always replace both windshield wiper blades, even if only one side is streaking, as the rubber on the opposite side is likely worn as well. It’s recommended to change the wiper blades on your TSX at least once a year, even if you don’t use your wipers much, as the sun wears out the wiper blades more than using them to wipe water.
Remember to consult your vehicle’s owner’s manual for specific instructions on changing your wiper blades before removing/installing them.
If you have any further questions or need additional assistance, feel free to ask!

Can I replace my wipers by myself?

And then slide the blade down to release it from the hook. Here. It is from another angle. Once you’ve removed the blade. You can reinstall new wiper blades by reversing this process.

Where is the switch for windshield wipers?

Make sure the ignition is on. Reach behind the right side of the steering wheel.

How are wiper arms removed?

And pull the arm. Out. If you are going to be lifting up the windshield wiper arm to remove. It make sure not to remove the windshield wiper. And this is so if for any. Reason it were to snap.

How much does it cost to replace a wiper switch?

The average cost for a Windshield Wiper Switch Replacement is between $210 and $239 but can vary from car to car.

How do I change my wiper blades?

Once it’s disengaged from the hook the blade can be removed. Position your new blade.

Can you replace windshield wiper switch?

The dash-mounted wiper switch is the easiest to replace. One or two screws secure it to the dash panel in most cases. In some, it’s a friction clip that secures it to the dash. Locate and remove the wiring connector from the back of the switch.

How do you remove stock windshield wipers?

Put your fingers in between here. Pull it through. Slide it right out just like that very simple.

How do you remove J Hook wiper blades?

And then slide the wiper blade upward. Finally we pull down the cap. Press it down until we hear a click. And pull off the blade guard. There you have. It.

Are wipers easy to replace?

Changing your wiper blades is typically a simple task. If you’re not confident about your skills, it may be a good idea to leave it to the professionals — it’s often done when you take your car in for an oil change.

How often should I change wiper blades?

Wiper blades should be replaced about every twelve months. However, colder climates may require replacement sooner. This video shows some of the signs to look for that may indicate it is time to replace your wiper blades.