How do you change the oil on a Ford Puma?

Changing the Oil on a Ford Puma
To change the engine oil on a Ford Puma, you will need to follow a few steps:
1. Prepare the Car:
– Place an oil catchment tray in position.
– Ensure all work is done with the engine stopped and wear gloves to prevent contact with hot liquid.
2. Drain the Oil:
– Use a 13mm spanner or socket to carefully remove the sump plug and fully drain the oil.
– After the sump has emptied, wipe clean the sump plug area with a paper towel.
– Replace the sump plug and washer, being careful not to over tighten it.
3. Replace the Oil Filter:
– Move up the container to allow the oil to drain out of the drainage hole immediately after removing the oil filter.
– Replace the oil filter every time when changing the motor oil.
– After a few seconds, the oil will fill all the channels, and the oil pressure warning light will go out.
– Dispose of the used filters at special collection points to protect the environment from pollution.
4. Refill with New Oil:
– Use 5W30 semi-synthetic oil, and about 4.5 liters are needed with a filter change.
– Put in 4 liters initially, then top up as needed.
5. Additional Tips:
– When screwing on the new oil filter, ensure it is hand-tight and use a clean oil to rub over the rubber seal.
– After the oil has finished draining, replace the plug and wipe up any excess oil.
Remember to always consult the owner’s manual for specific instructions and specifications for your Ford Puma.
If you have any further questions or need additional assistance, feel free to ask!

What kind of oil does a Ford Puma 1.0 Ecoboost take?

Engine oil CASTROL EDGE, V 0W-20, 5l, Synthetic Oil.

Where is the engine oil filter located?

In most vehicles, the oil filter is located on the engine block, near the oil pan. However, in others, the oil filter may be in a different location, such as above the engine, behind the radiator, or in the fender well. To find the exact location of your oil filter, you can refer to your car’s owner’s manual.

Is Ford Puma a reliable car?

Reliability. The Puma finished 17th out of 22 small SUV models in our 2023 What Car? Reliability Survey, below the Juke, the Countryman and the VW T-Roc but above the Kamiq. Ford as a manufacturer didn’t fare much better, claiming 27th place out of the 32 brands included.

How much oil does a Ford 1.0 EcoBoost take?

Capacities and Specifications – 1.0L EcoBoost

Item	Quantity
Engine oil fill capacity including the oil filter.	1.2 gal (4.6 L)
Engine oil fill capacity excluding the oil filter.	1.2 gal (4.4 L)
Engine coolant fill capacity.	2.2 gal (8.5 L)
Manual transmission fluid fill capacity.	0.4 gal (1.67 L)

How do you take the oil change?

1. Know When to Change the Oil. Engine oil or motor oil lubricates the parts of your engine to help it run smoothly.
2. Prepare Your Car.
3. Remove the Oil Fill Cap and Oil Plug.
4. Drain the Oil.
5. Remove the Old Oil Filter.
6. Install the New Oil Filter.
7. Replace the Plug and Add Oil.
8. Test the Oil.

Is it easy to change your own oil?

Relax, it’s easy! This is one of the easiest maintenance tasks you can perform on your car, and you don’t even need many tools to do it. Allow yourself plenty of time the first few oil changes. The more you do it, the more familiar everything becomes, and the easier it gets.

What are the downsides of the Ford Puma?

Ford Puma Common Problems and Solutions

• High Revs And Power Loss. Problem:
• Grinding Noise on Gear Change. Problem:
• Misfiring Engine. Problem:
• Rough Engine. Problem:
• Boot Door Slow To Open. Problem:
• Melting Steering Wheel. Problem:
• Heater Malfunction. Problem:
• Knocking From Front. Problem:

Do Ford Pumas keep their value?

Our experts predict the Ford Puma ST will retain around 63 per cent of its original value over three years and 36,000 miles. To get an accurate valuation on a specific model check out our valuation tool…

Where is the oil filter on a Ford Puma?

The oil filter is situated on the front section of the engine behind the radiator. Thanks Little Puma, in the video he passed the front part quite quickly so couldn’t see it’s location.

How much oil does a Ford Puma take?

Engine holds 4.2l. Officially you need 5w30 semi-synth.