How do you change the oil on a Chevrolet Traverse?

To change the oil on a Chevrolet Traverse, you can follow these general steps:
Gather the necessary tools and materials:
– New oil filter
– New engine oil (check your owner’s manual for the recommended type and quantity)
– Oil drain pan
– Jack stands or ramps
– Wrench or socket set
– Funnel
– Rag or paper towels
Lift the vehicle:
– Use jack stands or ramps to safely lift the front of the vehicle. Make sure the vehicle is secure before proceeding.
Locate the oil drain plug and oil filter:
– The oil drain plug is typically located on the bottom of the engine oil pan.
– The oil filter is usually located near the oil pan.
Drain the old oil:
– Place the oil drain pan below the oil drain plug.
– Use a wrench or socket set to loosen and remove the oil drain plug.
– Allow the old oil to completely drain into the pan.
– Once the oil has drained, replace the oil drain plug and tighten it securely.
Replace the oil filter:
– Use an oil filter wrench to remove the old oil filter.
– Apply a thin layer of new oil to the rubber gasket of the new oil filter.
– Screw the new oil filter onto the engine by hand until it is snug. Do not overtighten.
Add new oil:
– Locate the oil filler cap on the top of the engine.
– Remove the cap and insert a funnel.
– Slowly pour the new oil into the engine, using the recommended quantity from your owner’s manual.
– Replace the oil filler cap.
Lower the vehicle:
– Carefully lower the vehicle from the jack stands or ramps.
Reset the oil life indicator:
– If your vehicle has an oil life indicator, you may need to reset it. The process for resetting the indicator can vary depending on the model and year of your Traverse. Consult your owner’s manual or follow the instructions on the navigation screen, if applicable.
Please note that these are general steps, and it’s always a good idea to consult your owner’s manual for specific instructions and recommendations for your Chevrolet Traverse.

How do I reset my oil change required message?

First, turn your key to the “On” position (which is two turns of the key). Make sure to not start the engine. Completely press down the gas pedal three times within ten seconds, then turn off your vehicle. Start up the vehicle to check that your oil light has reset.

What kind of oil does a traverse take?

Mobil 1 – Advanced Full Synthetic Motor Oil 5W-30, 1 Quart (Part No. 24812)

Where is the oil filter on a traverse?

And untwist it this way yeah you know how to take an oil filter. Off. And then don’t forget 15 sockets on the drain.

How long can a Chevy Traverse go without an oil change?

7,500 Miles—oil Change Service
The Traverse SUV is incredibly reliable—so reliable, in fact, that you won’t need routine service until after the first 7,500 miles on the road. At this point, your service technician will need to perform an engine oil change. You’ll also need a new oil filter at this interval.

How many quarts of oil does a Chevy Traverse need?

6 quarts
Oil Grade: SEO20

Viscosity:	All TEMPS….5W-30 Below -20 F .0W-30
Capacity:	With filter 6 quarts. After refill check oil level.
Torque:	Oil Drain Plug…18 ft/lbs

How can I reset the oil service?

Push the gas pedal all the way down to the floor, then press the brake pedal down. After several seconds, a message on your dashboard should pop up and read “Service: Oil Reset in Progress.” Continue holding down the pedals until you see “Reset Complete.” Keep your feet pressing down on both pedals.

What is the best oil for Chevy Traverse?

2023 CHEVROLET TRAVERSE Motor Oil

• Valvoline Full Synthetic High Mileage with MaxLife Technology Motor Oil SAE 5W-30 5W-30.
• Valvoline Full Synthetic High Mileage with MaxLife Technology Motor Oil SAE 5W-20 5W-20.
• Valvoline Extended Protection Full Synthetic Motor Oil SAE 5W-30 5W-30.

Can I put oil in my car until I get an oil change?

Topping off the oil in your car is one way to avoid a conventional oil change (or any other kind of oil change). There is only one time this is a good idea, and that’s when your oil is very low and you need to get to your auto shop right away. Other than that, it’s best not to cut this particular corner.

What happens if oil change is overdue?

Complete Engine Failure – If you go long enough without an oil change, it could cost you a car. Once the motor oil becomes sludge, it no longer removes heat from the engine. This can lead to a complete engine shutdown that will require a brand new engine – or a new ride – to fix.

How do you reset the oil change soon on a Traverse?

Until you get to oil remaining so it shows here this vehicle has zero oil life remaining. And then you’re just gonna hold this check mark. Until it resets boom there it is.