AHG Auto Service » Make » Ford » How do you change the oil on a 2007 Ford Taurus?

How do you change the oil on a 2007 Ford Taurus?

Changing the Oil on a 2007 Ford Taurus
To change the oil on a 2007 Ford Taurus, you can follow these general steps:
1. Gather the necessary materials: You will need a wrench or socket, a drain pan, a new oil filter, a new oil filter gasket, a funnel, and the appropriate amount and type of motor oil for your vehicle.
2. Prepare the vehicle: Park the car on a level surface and engage the parking brake. It’s also a good idea to let the engine cool down before starting the oil change process.
3. Locate the oil drain plug: The oil drain plug is typically located on the base of the engine and can be accessed from underneath the car.
4. Drain the old oil: Place the drain pan underneath the oil drain plug, then use a wrench or socket to carefully remove the drain plug. Allow the old oil to fully drain into the pan. Once the oil has drained, wipe clean the drain plug area with a paper towel and reinstall the drain plug and washer. Be careful not to over-tighten the plug.
5. Replace the oil filter: Locate the oil filter, which is usually located near the oil pan. Unscrew the old oil filter using an oil filter wrench if necessary. Before installing the new oil filter, apply a small amount of oil to the rubber gasket on the new filter. Then, screw the new oil filter onto the engine by hand. Tighten it until the gasket makes contact with the engine, and then give it an additional three-quarters of a turn.
6. Add new oil: Locate the oil fill cap, which is usually on the top of the engine. Remove the cap and insert a funnel into the opening. Pour the appropriate amount and type of motor oil into the engine, as recommended by Ford for your specific Taurus model. Check the oil level using the dipstick to ensure it is at the correct level.
7. Clean up: Remove the drain pan and properly dispose of the old oil and filter at a recycling center or an auto parts store that accepts used oil.
It’s important to note that these are general steps, and it’s always a good idea to consult your vehicle’s owner’s manual for specific instructions and recommendations. Additionally, if you’re not comfortable performing an oil change yourself, it’s best to have it done by a professional at a trusted auto service center.
Remember to follow proper safety precautions and dispose of the used oil and filter responsibly. Regular oil changes are essential for maintaining the health and longevity of your vehicle’s engine.
I hope this helps! Let me know if you have any other questions.

How do I change my engine oil myself?

How to Change Your Oil

  1. Step 1: Jack It Up, Open It Up. First, you’ll want to lift the car high enough to give yourself room to work under it.
  2. Step 2: Unplug It, Drain It.
  3. Step 3: Off With the Old Filter.
  4. Step 4: Drain Plug in, Filter On.
  5. Step 5: Fill It Back Up with Oil.
  6. Step 6: Check the Oil Level, Check for Leaks.

What kind of motor oil does a 2007 Ford Taurus take?

Mobil 1 – Extended Performance High Mileage Full Synthetic Motor Oil 5W-20, 5 Quart (Part No. 15020)

How many quarts of oil does a 2007 Ford Taurus take?

4.5 quarts
Capacity: With filter 4.5 quarts. After refill check oil level.

Where is the engine oil filter located?

In most vehicles, the oil filter is located on the engine block, near the oil pan. However, in others, the oil filter may be in a different location, such as above the engine, behind the radiator, or in the fender well. To find the exact location of your oil filter, you can refer to your car’s owner’s manual.

Where is the oil plug on a 2007 Ford Taurus?

Either use a larger wrench or a hammer loosen. Up. We can do as your as you’re pulling the plug out just kind of push it in towards the pan. And pull it right out. And we’ll let that drain.

Where is the oil filter on a Ford Taurus?

Engine Oil and Filter Change
The drain bolt is the lowest bolt on the oil pan and is facing towards the rear of the vehicle. Inspect the drain bolt O-ring for any tears and then tighten. Locate the oil filter just in front of the drain bolt.

Where is the oil drain plug located?

The oil engine drain plug will be located within 1–2 feet (0.30–0.61 m) of the front of the vehicle, and sits directly beneath the engine. It’s on the bottom of a large tank referred to as the oil pan.

Where is the engine filter located?

Your engine air filter is located under the hood. The air filter box should be easily identifiable and simply opened by releasing latches or tabs by hand. Some air filter boxes may require a screwdriver or socket set to open.

Where is the oil plug drain plug?

And is located uh you want to put it underneath the oil drain plug. This is your oil pan. This is the plug you will open this plug.

What type of oil does a 2007 Ford Taurus take?

STP Conventional Engine Oil 5W-20 1 Quart
5W-20.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment