Changing the Oil on a 2007 Ford Five Hundred
To change the oil on a 2007 Ford Five Hundred, you can follow these steps:
1. Locate the Oil Drain Plug: Using a wrench or socket, carefully remove the drain plug located on the base of the engine. It is accessed underneath the car. Fully drain the oil into a suitable container.
– “Using a wrench or socket, carefully remove the drain plug and fully drain the oil. When the oil pan has emptied, wipe clean the drain plug area with a paper towel and install the drain plug and washer. Do not over tighten. The oil drain plug is located on the base of the engine. It is accessed underneath the car.”
2. Replace the Oil Filter: After draining the oil, replace the oil filter. For most Fords, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see the parts page to find a Ford Five Hundred oil filter wrench.
– “For most Fords, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Ford Five Hundred oil filter wrench.”
3. Refill with New Oil: Refill the engine with the appropriate type and amount of new oil. The 2007 Ford Five Hundred may require synthetic oil, which is a mix of synthetic and conventional oil, or conventional oil.
– “You can use synthetic oil in any modern vehicle. Many vehicles will require the use of 100% synthetic oil, others allow synthetic blend, which is a mix of synthetic and conventional oil, and conventional oil too.”
4. Reset the Oil Life Indicator: After changing the oil, you’ll need to reset the oil life indicator. Follow the specific process to reset the oil life indicator for the Ford Five Hundred.
– “The change oil light in a Ford 500 will begin to be displayed when there is 10% or less of the engine oil life remaining. Once you have the oil changed, follow this process to reset the oil life indicator.”
Remember to dispose of the old oil and oil filter properly at a designated recycling center.
I hope this helps you with changing the oil on your 2007 Ford Five Hundred!
Contents
- How do I reset my oil information?
- Where is my oil filter located?
- What is the gas mileage on a 2007 Ford Five Hundred?
- How many gallons of gas does a Ford Five Hundred hold?
- How many quarts of oil does a 2007 Ford Five Hundred take?
- Where is the oil plug to change the oil?
- How do you manually change oil?
- How do you reset the oil change maintenance?
- What size socket do I need to change my oil?
- How do you reset the oil life on a 2007 Ford Five Hundred?
How do I reset my oil information?
When you get to the menu. Press. The right arrow. Button.
Where is my oil filter located?
In most vehicles, the oil filter is located on the engine block, near the oil pan. However, in others, the oil filter may be in a different location, such as above the engine, behind the radiator, or in the fender well. To find the exact location of your oil filter, you can refer to your car’s owner’s manual.
What is the gas mileage on a 2007 Ford Five Hundred?
With the six-speed automatic, the Five Hundred is rated at 29 mpg on the highway — not too shabby for a full-size car. All-wheel drive substitutes the six-speed gearbox for a continuously variable automatic transmission. With that setup, highway gas mileage drops to 26 mpg. Four-wheel-disc antilock brakes are standard.
How many gallons of gas does a Ford Five Hundred hold?
19.0 gallonsCompare Side-by-Side
| 2005 Ford Five Hundred AWD | |
|---|---|
| Annual Fuel Cost* | $2,600 |
| Cost to Drive 25 Miles | $4.30 |
| Cost to Fill the Tank | $62 |
| Tank Size | 19.0 gallons |
How many quarts of oil does a 2007 Ford Five Hundred take?
Oil Grade: SEO15
| Viscosity: | All TEMPS….5W-20 |
|---|---|
| Capacity: | With filter 6 quarts. After refill check oil level. |
| Torque: | Oil Drain Plug…19 ft/lbs |
Where is the oil plug to change the oil?
When you finish with preparations, you must do the following to change the oil: Look under the car and locate the drain plug: It is a large nut or plug located under the oil pan (large tank) at the bottom of the engine.
How do you manually change oil?
How to Change Your Oil
- Step 1: Jack It Up, Open It Up. First, you’ll want to lift the car high enough to give yourself room to work under it.
- Step 2: Unplug It, Drain It.
- Step 3: Off With the Old Filter.
- Step 4: Drain Plug in, Filter On.
- Step 5: Fill It Back Up with Oil.
- Step 6: Check the Oil Level, Check for Leaks.
How do you reset the oil change maintenance?
Button located on the steering wheel. Select info scroll down until you can select remaining oil life on the menu. Press and hold the center of the thumbnail. Until it says your oil light is 100.
What size socket do I need to change my oil?
Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine. Make sure to place a bucket and some newspaper under the car’s engine to catch all the draining oil.
How do you reset the oil life on a 2007 Ford Five Hundred?
Button once you’ve located those buttons you want to press and release the setup. Button until the oil life percentage is displayed. And then it will say reset if new is displayed.
