How do you change a tire on a Toyota Hiace?

Steps to Change a Tire on a Toyota Hiace
Changing a tire on a Toyota Hiace may seem challenging, but with the right knowledge and tools, it can be done. Here are the steps to change a tire on a Toyota Hiace:
1. Prepare the necessary tools: Before starting, make sure you have the following tools: a spare tire, a tire wrench, a jack, and a flashlight.
2. Find a safe location: Park your Hiace on a flat and stable surface away from traffic. Engage the parking brake and turn on the hazard lights for added safety.
3. Loosen the lug nuts: Use the tire wrench to loosen the lug nuts on the flat tire. Turn them counterclockwise, but do not remove them completely at this stage.
4. Position the jack: Locate the designated jack points on the Hiace. These are usually marked with notches or arrows on the vehicle’s frame. Place the jack securely under the appropriate jack point.
5. Raise the vehicle: Use the jack to lift the Hiace until the flat tire is off the ground. Make sure the vehicle is stable and secure before proceeding.
6. Remove the lug nuts and flat tire: Completely remove the loosened lug nuts and set them aside. Carefully take off the flat tire and place it aside.
7. Install the spare tire: Lift the spare tire onto the wheel hub and align the lug nut holes. Push the spare tire onto the hub until it is fully seated.
8. Tighten the lug nuts: Begin tightening the lug nuts by hand until they are snug. Then, use the tire wrench to further tighten the lug nuts in a star or crisscross pattern. This ensures even tightening.
9. Lower the vehicle: Use the jack to lower the Hiace back to the ground. Remove the jack and make sure the spare tire is securely in place.
10. Tighten the lug nuts again: With the vehicle on the ground, use the tire wrench to give the lug nuts a final tightening. Be careful not to overtighten them.
11. Check the tire pressure: Use a tire gauge to check the pressure of the spare tire. Make sure it is inflated to the recommended pressure.
12. Stow the flat tire and tools: Place the flat tire, tire wrench, and jack back in their designated storage areas in the Hiace.
Remember, these steps are a general guide, and it’s always a good idea to consult your vehicle’s owner’s manual for specific instructions and safety precautions.

How do you change a tire step by step?

Below, I’ve broken down how to change a tire in 10 simple steps.

1. Find a Safe Place to Pull Over.
2. Check for Materials.
3. Loosen the Lug Nuts.
4. Lift Your Vehicle Off the Ground.
5. Remove the Lug Nuts and the Tire.
6. Place the Spare Tire on the Car.
7. Replace the Lug Nuts.
8. Lower Your Vehicle and Begin Tightening.

Where is the spare TYRE on a Toyota HiAce van?

For Toyota Hiace campervans (AU/NZ) – tools are under the side step (sliding door entrance), spare tyre is under the vehicle, locate the nut at the back of the cabin, under the side seat (passenger side) and lower using your tools.

Where is the jack in a Toyota HiAce van?

When you open the sliding door on the left side, there is a lid, in which the in-car jack is stored. Make sure you don’t panic in case of an emergency. The jack-up point is also specified in the instruction manual, so please check. The front side should be applied to this position of the frame.

What are the 5 steps to changing a tire?

How to Change a Flat Tire in Five Steps

1. Get Safe. Before you exit your vehicle, pull over or find a place away from the rush of traffic on the road.
2. Grab Your Tools. Once you’re in a safe location, locate all the necessary tools to change your flat tire.
3. Loosen and Lift.
4. Put the spare tire on.
5. Lower and tighten.

Where do you put the jack under a van?

So it’s firmly resting on the stand. And it’s resting on the jack. Now that my brake job is completed. I can put the tires back on and lower the vehicle. Now it’s time to mount the tire.

Do Toyota vans have spare tires?

The new Sienna is considered the current mini-van market leader. For 2021-2024 the Toyota Sienna has almost everything you could ask for, except for one critical detail. Your Sienna may not be equipped with a spare tire.

Where is the spare wheel located?

Your tire may be located in the cargo area, trunk, or under the rear of the vehicle. To find the location of the spare tire in your vehicle, enter your vehicle year and model in your Owner’s Manual under Changing a Road Wheel or Changing Tires.

What wheels fit a Toyota HiAce?

Toyota: Hiace, 6/139.7 Bolt Pattern – All models, 2004 Onwards

Wheel	Sizes (Inches)	Features
Commando – Large Cap	16×7, 16×7, 17×7	Satin Black
Magnum II	15×7, 16×7	Black M-Face
Monster – Large Cap	16×7, 16×7	Black Machine Face
Ranger – Black	16×7	Black

Where do you put a jack on a van?

Locate the jack point on the vehicle
Your owner’s manual should give you the location of jack points. Usually there’s one on each side behind the front wheels and in front of the back wheels, close to the rocker panels. There may be central jack points located behind the bumpers (front and rear).

How do you change a tire in 5 steps?

Here just tighten the lugs. So that they feel equally snug and require some elbow grease to break loose again and boom. You’re back on your way.