How do you change a license plate light on a Dodge Journey?

Changing a License Plate Light on a Dodge Journey
To change the license plate light on a Dodge Journey, you can follow these steps:
1. Gather the necessary tools: You will need a flat screwdriver or a knife.
2. Locate the license plate light: Face your license plate and look for a transparent cover with a notch.
3. Open the license plate bulb slot: Insert the flat part of the screwdriver or knife into the notch and lever on the plastic window to open the license plate bulb slot.
4. Remove the old bulb: Use the screwdriver, knife, or your fingers to eject the old bulb from its spot.
5. Install the new bulb: Position the new license plate light bulb in place.
6. Test the light: Before reassembling, reconnect your battery and verify that the new light is working properly.
Please note that these steps are a general guide and may vary slightly depending on the specific model and year of your Dodge Journey. It’s always a good idea to consult your vehicle’s owner’s manual for detailed instructions tailored to your vehicle.
If you prefer visual instructions, you can also refer to video tutorials available on platforms like YouTube, where you can find step-by-step demonstrations of how to change the license plate light bulb on a Dodge Journey.
I hope this helps! Let me know if you have any other questions.

How do you change a license plate bulb?

Then just turned the light housing counterclockwise to release it. Then you’re able to pull out your old bulb. And install your new bulb. Then you can reinstall your lighthousing.

How do you remove a number plate light?

Put it here in this latch. And just pull it out you don’t have to unscrew. Anything this is the way to pull it out and replace the bulb. After that once you replaced. It just push it back into place.

How do I change my bulb?

Hold the bulb lightly but firmly and turn anticlockwise until the bulb comes loose and away from the fitting.

1. Replace. Replace the bulb with the same fitting bulb and insert in reverse of how you removed the old one.
2. Restore power. Once the bulb is in, turn the power back on again and switch on the light.

How to change interior lights on Dodge Journey?

For this installation you will need a trim. Tool first locating the dome light pry this side. Then pry along the edge accordingly. The lens will pop.

How do you change a LED license plate light?

Install LED License Plate Light

1. Take a flat head screwdriver and remove the license plate housing cover.
2. Remove the bulb housing.
3. Remove the stock license plate bulb.
4. Directly replace with the new LED license plate bulb.
5. Put everything back the same way it was removed.

Why wont my interior lights go out?

Either one of the door jamb switches is stuck, the dimmer switch for the interior lights is turned all the way up, or there is a short in the ground wire. Of course, on later model cars, the first place to look is at the switch on the dome light itself, as that may be turned on as well.

Do license plate lights have a fuse?

Number. Ok right here it’s a fuse number I believe its 2025 f25 fuse so I’ll go ahead grab it with the pliers. Guys. Ok it’s more convenient to use the plugs. And pull it out and this fuse.

How do you remove a number plate without screws?

Some stuck-on number plates can easily and quickly be removed. Place your fingers under the edge of the number plate and pull firmly but evenly. This may be enough to unstick the plate. If the plates are more firmly attached, the best technique is to use some dental floss, fishing line or string to aid removal.

How do you change an interior light in a car?

Into. Place I’m just going to press it and the bulb pops. Out okay so here’s the bulb we just removed. And actually the filament.

Why are my car number plate lights not working?

Possible Solutions: Check/Replace all faulty Wiring/Connector(s). Check/Replace Fuse(s). Verify correct light bulbs are installed.