How do you change a license plate light on a Chevy Equinox?

How to Change a License Plate Light on a Chevy Equinox
To change the license plate light on a Chevy Equinox, you can follow these steps:
1. Open the rear lift gate of your Equinox.
2. Locate the license plate light cover and assembly unit over the license plate.
3. Remove the light cover and assembly unit by sliding it towards the left side of the vehicle until it locks.
4. Replace the burnt-out bulb with a new one. You can buy a W5WLL bulb from an auto parts store.
5. Once the new bulb is in place, reattach the light cover and assembly unit by sliding it towards the right side of the vehicle until it locks.
Please note that the specific steps may vary slightly depending on the model year of your Chevy Equinox. It’s always a good idea to consult your vehicle’s owner’s manual for detailed instructions.
I hope this helps! Let me know if you have any other questions.

How much does it cost to replace a headlight on a Chevy Equinox?

The average cost for a Chevrolet Equinox Headlight Bulb Replacement is between $173 and $202. Labor costs are estimated between $48 and $60 while parts are priced between $126 and $142. This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed.

What headlight bulb is in a 2014 Equinox?

SYLVANIA – H11 XtraVision – High Performance Halogen Headlight Bulb, High Beam, Low Beam and Fog Replacement Bulb (Contains 2 Bulbs)

How to remove a license plate light bulb?

Unscrew the licence plate and the bracket to access the light easier. Lever out the licence plate lamp with a screwdriver. In most cases there is a notch next to the lamp for exactly this purpose; in some cases the lamp does not have to be levered out but unscrewed instead. Then disconnect the power connector.

How do you change a license plate light on a 2012 Chevy Equinox?

And test it. Line up the tabs on the socket with the slots in the housing. Install the socket. And turn it clockwise Slide the inside of the assembly in first then push it up into place.

How do you change a number plate light bulb?

Put it here in this latch. And just pull it out you don’t have to unscrew. Anything this is the way to pull it out and replace the bulb. After that once you replaced. It just push it back into place.

What color is the license plate light?

white light
A license plate light is required on the rear of a vehicle. A tail lamp or a separate lamp must illuminate the rear registration plate with a white light and render it clearly legible from a distance of fifty feet.

How do you change a lightbulb in a 2013 Chevy Equinox?

And then the headlight should be right behind. There and there’s the light right in. There. Just twist that to the left about 45 degrees it should pop right. Out.

How do you change a LED license plate light?

Install LED License Plate Light

1. Take a flat head screwdriver and remove the license plate housing cover.
2. Remove the bulb housing.
3. Remove the stock license plate bulb.
4. Directly replace with the new LED license plate bulb.
5. Put everything back the same way it was removed.

How do you install license plate lights?

Then you’ll pop your OEM bulb out. And slide the connection for your new housings. Into the slot. Do this to both sides reinstall. Your trunk trim and voila.

Do license plate lights stay on?

Your license plate light should switch off when you turn off your car’s power. If the light stays on even when your ignition is off there may be a faulty switch and it needs to be fixed.