How do you change a license plate light on a 2012 Subaru Impreza?

Changing a License Plate Light on a 2012 Subaru Impreza
To change the license plate light on a 2012 Subaru Impreza, you will need to follow these steps:
1. Open the trunk of your Subaru Impreza.
2. Remove the liner inside the trunk to access the license plate bulb housing.
3. Locate the license plate bulb housing and remove the old bulb.
4. Insert a new bulb into the housing.
5. Reassemble the liner inside the trunk.
6. Test the light to ensure it is working properly.
Please note that the specific steps may vary slightly depending on the model and trim level of your Subaru Impreza. It is always recommended to consult the owner’s manual for detailed instructions.
Source:
– Source : ‘LED License Plate Light Bulb Replace | 5th Gen Subaru Impreza Forum’
I hope this helps! Let me know if you have any other questions.

Can I change my own tag light?

Replacing your car’s tail light bulbs is a simple and straightforward procedure. The rear light bulbs are usually housed in a single unit that’s easy to access from inside the boot. Haynes has full step-by-step information on how to do this. Most tail light bulbs are filled with halogen gas, and are readily available.

What color is the license plate light?

white light
A license plate light is required on the rear of a vehicle. A tail lamp or a separate lamp must illuminate the rear registration plate with a white light and render it clearly legible from a distance of fifty feet.

How do you change a license plate light on a 2014 Subaru Crosstrek?

So I’m gonna push them to the inside. And lift up at the same time with your fingers. Okay guide them out of the tailgate. So what you’re doing.

How do you change a LED license plate light?

Then just turned the light housing counterclockwise to release it. Then you’re able to pull out your old bulb. And install your new bulb. Then you can reinstall your lighthousing.

How do you put a front license plate on a Subaru Impreza?

And they’re about the size of a pinpoint. So there’s one here. And one right there that is where you’re going to screw. Your screws in to mount your license plate. So it’s very easy to do i suggest.

How to replace Subaru Impreza license plate lights?

And get it out. There. It is grab the bulb. And pull it out straight you may have to wiggle the ball but it’ll come right. Out. There is about the ball replacement.

How to remove a license plate light bulb?

Unscrew the licence plate and the bracket to access the light easier. Lever out the licence plate lamp with a screwdriver. In most cases there is a notch next to the lamp for exactly this purpose; in some cases the lamp does not have to be levered out but unscrewed instead. Then disconnect the power connector.

How do you change a license plate light on a 2016 Subaru Impreza?

Here these are 168s is what this light bulb is that goes in there. So you just get a new 168. And be able to install.

Does an LED license plate light need a resistor?

The reason: The amount of light from the LED is proportional to the current going though it. That is what you want to control. But the voltage across an LED changes by age, by temperature, and by each individual LED. So if you don’t put a resistor in series with it, then some LEDs will be too bright and burn out.

What are license plate lights called?

Tag lights, also known as license plate lights, allow other vehicles to see your license plate in the dark. If the tag lights on your vehicle go out, you need to replace them as soon as you can or else you may get pulled over.