How do I reset my Subaru Hatch?

How to Reset a Subaru Hatch
If you are experiencing issues with your Subaru hatch and need to reset it, there are a few methods you can try. Here are the steps you can follow:
1. Method 1: Unlock the Subaru: Make sure your Subaru is unlocked. If the gate is locked, the rear gate will not open. Look for the back gate opener button on the driver-side dashboard of your vehicle. Press the button to unlock the gate.
2. Method 2: Press and Hold the Rear Liftgate Close Button: With the liftgate open and not moving, press and hold the rear liftgate close button until it beeps at least four times. The rear liftgate close button is located on the door jamb of the rear liftgate and is only accessible when the liftgate is open.
3. Method 3: Manually Open the Hatch: If the above methods do not work, you can manually open the hatch. Locate the small plastic square by the latch from the inside of the car (pull down the back seats first). Move the plastic square upward to manually open the hatch. Please note that this method should only be used in emergency situations and not on a regular basis, as it could cause damage.
It’s important to note that these methods may vary depending on the specific Subaru model you have. If you are unsure or need further assistance, it is recommended to consult the owner’s manual or contact a Subaru dealership for guidance.
I hope this helps! Let me know if you have any other questions.

Why is my trunk not closing automatically?

A variety of issues can cause this problem, such as a malfunctioning trunk release mechanism, a jammed locking mechanism or release lever, or an obstruction preventing the trunk from closing correctly.

Why is my liftgate not working?

The most common liftgate issues can be traced back to the motor or motor start solenoid. If you hear a clicking noise when the switch is activated, more than likely you have a bad solenoid. Using a small jumper cable, bypass the solenoid by putting direct power to the motor to see if it will run.

How do I know if my liftgate actuator is bad?

Symptoms of a bad trunk lock actuator include the trunk refusing to lock or close, the automatic trunk pull-down not working, and the trunk not opening with the key fob but opening with the traditional key.

Why wont my Subaru trunk open?

If you hold the button on the hatch itself for several seconds, it’ll beep and reset itself. If that doesn’t work, dealer may have to look at it. Make sure you press the door unlock button on the driver’s side door before doing the long press on the hatch button on the dash.

How do I reset my Outback liftgate?

To reset the electronic rear latch mechanism, close the gate, press and hold the exterior latch button for 10 seconds.

How do you reset the hatch height on a Subaru Outback?

Then what you do you press and hold this button the close button. And you get that beeping and those lights flashing now it’ll only open to that height. And we’ll just do that from the key fob. Here.

How do I fix my Subaru trunk not closing?

Solution – while the hatch was down, Hold the button under the Subaru emblem for 10 seconds. This was a hard reset and after that the hatch worked as normal. Easy, no worries.

Is it bad to manually open a power liftgate?

The only drawbacks are that they are a more expensive option than a manual liftgate and are more expensive to fix if something breaks. For that reason, a lot of people ask, “Can I manually open and close my power liftgate?” The simple answer is yes.

How do you manually open a Subaru hatchback?

To open the power rear gate with the fob simply press and hold the power rear gate. Button to pause the door press the button again pressing the fob a third time will close the rear gate.

How do I reset my Subaru rear hatch?

How to reset your Subaru rear hatch. When this issue is occurring, the car will beep three times each time you press the rear gate button. The natural response is to release the button once the car beeps. To reset the rear door, keep holding the rear hatch release button until you hear a soft “thuck”.