How do I know if my Subaru axle is bad?

Signs of a Bad Subaru Axle
If you suspect that your Subaru axle may be bad, there are several signs to look out for:
Clicking Sound When Turning: One of the most common symptoms of a bad CV axle is a clicking noise when turning, especially during sharp turns at lower speeds. This is often an indication of an issue with the outer CV joint.
Vibration While Driving: If the shaft of your CV axle is bent, you may experience a vibration while driving, which becomes more pronounced as you increase speed. It’s important to have the area surrounding the CV axle inspected for physical damage.
Grease on the Inside of Your Tire: Both joints of the CV axle are protected with a rubber boot that contains grease. Any tear or crack in the boot can result in grease appearing on the inside edge of the tire. Regularly checking these boots is important, as catching a tear early may allow for a repair before the joint is compromised.
If you notice any of these symptoms, it’s advisable to schedule a service appointment immediately, as a bad CV joint will likely mean that the entire CV axle will need to be replaced . Regular inspection of the axles during service appointments can help identify and address issues early, potentially preventing further damage to your Subaru.

Is it worth fixing an axle on a car?

Broken or bent, a bad axle must be replaced as soon as possible! It is a serious safety issue, and driving with a broken axle causes major damage to your car. Because the axle is a vital part that keeps the wheels in place and supports your car’s weight.

What happens if axle goes out while driving?

Car axles are susceptible to failure like any other car component over time. If the axle of your car breaks while you are driving, the vehicle will become immobile. In certain uncommon instances, the wheel bearing may become locked, causing the wheel to separate from the suspension.

Is it OK to drive on a bad axle?

Can You Drive With a Broken Axle? The simple answer is ‘yes’ but there are serious consequences if you go ahead and drive with a broken axle. Doing this may cause serious mechanical damages to other parts of your vehicle. For example, it may damage the tires or cause them to wear off much faster.

What does a worn out axle sound like?

“Clicking” Noises When Turning
Though it’s sometimes described as a loud click and sometimes described as a pop, this noise is unmistakable once you hear it. It presents itself when you turn the vehicle, and it’s due to the loose joints of a worn CV axle.

How do I know if my axle is worn out?

These are the 5 easiest ways to identify if you have a damaged CV axle.

1. A Tear in the Boot.
2. Grease Found on the Inside of Your Wheels.
3. Knocking Sound.
4. Clicking While Turning.
5. Vibration While Driving.

What happens when a CV axle fails while driving?

The Constant Velocity is sealed by a boot. This boot may get damaged, and when this happens, the joint will wear out and eventually fail. If you drive a car with a damaged CV, the joint will disintegrate further, making driving impossible. You’ll not be able to control the vehicle and may get involved in an accident.

What does a worn out CV axle sound like?

Today I’ll be going through both the first symptom you might be experiencing with your car is hearing a clunky noise when accelerating. In some situations. You might hear it when braking hard this

How much does it cost to fix a Subaru axle?

The cost of parts ranges between $760 and $1,030, while labor cost is between $170.00 and $180. Replacing a single axle usually takes about 1.5 to 3 hours, so replacing all four others can take up to 12 hours, which increases the cost if you factor in both parts and labor.

How do you diagnose a bad CV axle on a Subaru?

But I don’t get much noise but then if I turn. It. You hear that Rumble. And feel that Rumble that’s the u-joints. Trying not to break in half. So. If when you’re driving straight.

What are the symptoms of a bad axle?

4 Signs You Have A Bad CV Axle

• Clicking/Ticking Sounds. A loud clicking or ticking sound when turning your vehicle is one of the most common symptoms of a bad CV axle.
• Grease On The Inside Of Your Wheel.
• Vibrations That Worsen With Increased Speed.
• Knocking Sounds.