How do I identify my Ford cylinder head?

Identifying Your Ford Cylinder Head
To identify your Ford cylinder head, you can follow these steps:
1. Check Under the Valve Cover: Look for the code number on top of the head under the valve cover. If you have the valve cover off, look for any code number at either end of the head.
2. Inspect the Bottom of the Head: The code number may be located on the bottom of the head, but this may require the head to be removed for inspection.
3. Look for the Code on the Side of the Head: Check the side of the head just under the valve cover lip for the code number.
It’s important to note that replacing cylinder heads correctly is crucial during the rebuilding process, and getting the exact duplicate replacement part is essential, whether purchased from a junkyard or a dealer.
These steps should help you in identifying your Ford cylinder head. If you need further assistance, feel free to ask!

How do I identify a Ford part?

The first digit of the prefix. Is the decade the part was first used the second digit is for the year of that decade.

Where is the casting number on a Ford engine?

For FORD engines, the block casting number is usually underneath the engine which makes it impossible to read when the engine is still in the vehicule/boat.

Where is the casting number on a Ford FE head?

The casting number is on the right (passenger) side of the block, in the front. FE (330-428 SCJ) note: nearly all FE blocks have 352 cast on the front of them.

Where are the casting numbers on Ford 302 heads?

Head casting number is under the cylinder head. It must be removed to see it. Date code location is under the valve cover.

How do I know what cylinder heads I have?

Cylinder heads may be identified by their casting number, located between the #4 and #5 pushrods. General identification is as follows: 850-1100 heads have a heater tap at 90 degrees to the centerline of the engine. The space between the thermostat housing and the valve cover is small, at 1/16″

How can you determine that the cylinder head needs to be replaced?

9 Signs That It’s Time to Replace Your Cylinder Head

1. Loss of Engine Power: A worn-out or damaged cylinder head can also result in a loss of engine power.
2. Poor Compression:
3. Coolant Contamination:
4. Engine Misfires:
5. Excessive Smoke:
6. Coolant Loss:
7. Visible Damage:
8. Persistent Issues:

How do you decode Ford engine casting numbers?

The first digit is a letter and represents the decade in which the part was designed. A = 1940s, B = 1950s, C = 1960s, D = 1970s, E = 1980s, F = 1990s. The second digit will be a numeral, and will represent the year within that decade (i.e. C2 = 1962; E7 = 1987).

How do you decode a Ford engine block number?

A = 1940s, B = 1950s, C = 1960s, D = 1970s, E = 1980s, F = 1990s. The second digit will be a numeral, and will represent the year within that decade (i.e. C2 = 1962; E7 = 1987). The third digit is usually another letter, but can also be a numeral in rare cases, and it signifies the vehicle the part was designed for.

How do I identify my Ford engine?

The tag is a series of numbers and letters etched in and used to decipher the year, make, and model of you engine. It is found underneath the bolts on the left or right side of the engine, near the front of the car. You can find the tag here on all six-cylinder engines made after 1964, and on some V8 engines.

Do cylinder heads have serial numbers?

You can identify the type of head by the raised casting part number found on the bottom, usually on the carb side. By comparing this with the serial number on the front, you may be able to determine if an incorrect head has been restamped.