How do I get my Subaru out of anti theft mode?

How to Get Your Subaru Out of Anti-Theft Mode
If your Subaru is in anti-theft mode and you’re unable to start it, there are a few steps you can try to resolve the issue. Here are some suggestions based on the search results:
1. Check the battery: A weak or dead battery can sometimes trigger the anti-theft system and prevent the car from starting. Make sure the battery is fully charged and in good condition.
2. Use the mechanical key: If your Subaru has a mechanical key, try using it to unlock the driver’s door. Some users have reported that manually unlocking the door with the mechanical key can reset the anti-theft system and allow the car to start.
3. Turn the ignition on: If the above steps don’t work, try turning the ignition to the “On” position and leaving it there for a few minutes. This may give the car’s computer time to recognize the key and reset the anti-theft system.
4. Consult a professional: If none of the above steps work, it may be necessary to consult a Subaru dealer or a qualified mechanic for further assistance. They have the expertise and tools to diagnose and resolve issues with the anti-theft system.
Remember, these suggestions are based on user experiences and may not work in all cases. If you’re unsure or need more specific guidance, it’s best to reach out to a professional for assistance.
I hope this helps! Let me know if you have any other questions.

Why is my car stuck in theft mode?

Method 1: Check the cylinder and key
Keep in mind that your key fob might not be dead, but the battery is simply not installed correctly. Step 2: Check the door lock cylinder. If your vehicle has been damaged, during an attempted break-in or theft or otherwise, the anti-theft system might have been triggered.

Why is the security indicator light blinking on my Subaru Outback?

That’s the Security Indicator Light , and it’s blinking, it’s telling you that the car’s security sytem is armed. When the car is locked and off, the Security Indicator Light will blink steadily. It will trigger shortly after the engine has been turned off and the key has been removed from the ignition.

How do I reset my car immobilizer?

To override the immobiliser or alarm, in the event of a flat remote battery. In any mode, turn the Ignition on and press the hidden push button for +/- 2 seconds until the unit chirps once, the system will be reset. This is a once off override.

Why wont my anti-theft turn off?

The first thing to do would be to check the key fob battery. In case, it is dead and has not disabled the system; the false anti-theft alarm is likely to activate. Replace the battery if it dies, with a fresh one. Next, you could check the door lock cylinder.

Is there a fuse for anti-theft system?

The anti-theft or car alarm fuse is usually found in the fuse box on the driver’s side. In some vehicles, the anti-theft fuse can be in the fuse box under the hood that’s also on the driver’s side. The fuse box should be behind the air filter.

Will disconnecting battery reset anti-theft alarm?

Car alarms rely on the electronic component of the vehicle, and disconnecting the battery should both silence the siren and reset your alarm. Open up the hood, locate the battery, and with a wrench, remove the negative terminal. Then reconnect it after a minute has passed.

How do I get my car out of security mode?

Start the Car with the Key:
Some vehicles have a system that recognizes the key’s chip or transponder. Insert the key into the ignition, turn it to the ‘On’ position (without starting the engine), and wait for a few moments. In some cases, this can reset the anti-theft system, allowing you to start the car.

How can I reset the anti-theft system?

Manually reset the anti-theft system by turning your car on and off. Insert your key and hold it in the “off” position for 30 seconds. Then, turn the key to “on” and wait at least 10 minutes. Flip the position back to off for 30 seconds and repeat the cycle.

How do you turn off the anti-theft system on a Subaru Outback?

On your Outback you might want to do this in the valet. Situation. Or some other situation where maybe you’re in and out of the car a lot and you don’t want to accidentally trigger the alarm.

How long does it take for the anti-theft system to reset?

Put the key in the ignition and rotate forward two clicks to the “On” position that makes the dashboard light up, but don’t try starting the car. Leave the key there for 15 minutes; it doesn’t always take that long, but it can. After that time, check to see if the anti-theft light has gone out, if one was lit up.