Based on the search results, Toyota uses metric brake lines. The brake line fittings for Toyota vehicles are typically 10mm x 1.0 . It is important to note that the brake line diameter for Toyota vehicles is 3/16″ or 4.75mm, which is the metric equivalent of 3/16″.
Contents
- What size brake line fittings are on a 2001 Toyota Tacoma?
- What size are metric brake lines?
- What size are brake lines in MM?
- What brake line flare does Toyota use?
- What are the metric sizes for brake lines?
- What size are Toyota brake line nuts?
- What size brake lines does Toyota use?
- What is the most common brake line fitting size?
- Is there metric brake line?
- Who makes Toyota OEM brake parts?
What size brake line fittings are on a 2001 Toyota Tacoma?
The brake line has (1) male & (1) female M10-1.0 inverted flare fittings and is supplied with a retention clip. DOT-approved extended brake lines – suitable for lifts up to 3.5″ [89 mm].
What size are metric brake lines?
The two most common brake lines found are 3/16″/4.75mm and 1/4″.
What size are brake lines in MM?
The two most common brake lines found are 3/16″/4.75mm and 1/4″. The smaller size is 3/16″/4.75mm brake line, CNF-3; and the larger size is 1/4″, CNF-4. 3/16″ is found on virtually all cars and trucks made in the world.
What brake line flare does Toyota use?
Toyota Brake Flare Type
Toyota brake tube ends need a double flare, also known as an inverted flare. You should not confuse this with a bubble flare or a single flare. If you try to use bubble/single flares on your brake components they will leak.
What are the metric sizes for brake lines?
Metric Brake Line Fitting Size Gauge
- Easily check ISO/Metric thread sizes for the most common thread sizes found in automotive braking systems.
- Check thread sizes for: M9 X 1.0, M10 X 1.0, M11 X 1.5, M12 X 1.0, M12 X 1.5, M13 X 1.0, M13 X 1.5, M14 X 1.5, M16 X 1.5.
- Each size has a male and female end checker.
What size are Toyota brake line nuts?
Brake line tube nuts (M10 x 1.0 size)
What size brake lines does Toyota use?
The standard Toyota brake line fitting is 10mmx1.
Most fittings take a 10mm wrench for the hard lines (the male fittings) and 14mm for the female fittings. If you’re replacing stock soft lines for extended Toyota brake lines you’ll need both 10mm and 14mm to separate them.
What is the most common brake line fitting size?
Almost every car or truck worldwide utilizes a 3/16-inch brake line, also referred to as a CNF-3. The other most common brake line is the ¼ inch. This size was routinely used in the 1950s, so if your truck or car was manufactured in that era, you would need the ¼ inch.
Is there metric brake line?
BelMetric has you covered with Metric and Inch Brake Ends, Tees and Unions made from Steel or Brass and Brake Lines made of Copper Nickel or Stainless Steel. Metric Fitting sizes include coarse and fine M10, M11, M12, M14 and M16 thread configurations.
Who makes Toyota OEM brake parts?
Akebono brake products: trusted by original equipment manufacturers worldwide. Akebono’s OEM customers include Ford Motor Company, General Motors, Honda, Isuzu, Mazda, Mitsubishi Motors, Nissan, Stellantis, Subaru, Toyota and Volvo.
