Does Honda still use break in oil?

According to the search results, Honda does not use a specific “break-in oil” in their new vehicles. Instead, they use assembly lubes during the manufacturing process that contain a high molybdenum percentage. These assembly lubes help with the initial lubrication of the engine components . The factory fill oil is recommended to be run for at least 5000 miles, as it contains a lot of molybdenum to aid in the break-in process. It is important to note that the first oil change should be done when the Maintenance Minder (MM) indicates a certain percentage, typically between 10% and 15%. However, some Honda owners prefer to change the oil earlier for various reasons, such as removing any debris or contaminants that may have accumulated during the break-in period. Ultimately, it is up to the owner’s preference, but it is recommended to follow the manufacturer’s guidelines and consult the owner’s manual for specific recommendations for each Honda model.

How do you break-in a new Honda engine?

Re: break in
run the motor for 15min, adjust idle and fuel, make sure its not too rich and too lean, this is very important for the first few minutes of a motors life. you dont want to wash out the rings. after the car is idling and fuel is stoich (14.7) check for oil + coolant + fuel leaks.

What year did Honda have oil dilution problems?

According to a recent class action lawsuit,drivers of certain 2018-2023 Honda vehicles may experience stalling and oil dilution. Manufacturing defects in the engines of affected vehicles can cause the car’s oil to be diluted with fuel, causing significant wear and damage to the engine.

What’s the best break in oil for a new motor?

Some people prefer to use a SAE 30 non-detergent motor oil to break in a newly built engine. Others use a conventional 15W-40 diesel oil because it contains a higher level of ZDDP than motor oils for gasoline engines.

Does Honda use break in oil for new cars?

There is no “break in oil” in new Honda’s and no break in period as were were in days gone by. What the engine does have is some molybdenum lubricant left over from manufacture and assembly of the engine.

When should the first oil change be for a new car?

Breaking in a new car is no longer necessary, but getting that first oil change will always be vital. When is the best time to get the first oil change on a brand new car? Make sure you change it for the first time at 1,500 miles, unless the manufacturer has a different recommendation for your vehicle.

What not to do during car break-in period?

Every car is different, so the first thing you want to do is check the owner’s manual. In most cases, it will tell you to avoid hard braking and acceleration during the first 1,000 miles or so.

How many miles do you have to break in new oil?

As a rule, use break-in motor oil for 500 – 1,000 miles, or 10-12 full heat cycles. If using it for 10-12 full heat cycles, you want to allow the engine to reach full operating temperature and cool down completely between cycles. Use engine break-in oil only long enough to seat the engine.

Does Honda recommend a break-in period?

For most vehicles, Honda recommends avoiding sudden acceleration, full throttle operation, and towing a trailer, if applicable, during your new vehicle’s first 600 miles.

What is the best oil for break-in engines?

Many people say a conventional mineral-based SAE 30 motor oil that contains extra extreme pressure additive (ZDDP and/or moly) and little or no friction modifiers is best for engine break-in.

Do manufacturers use break in oil?

Some manufacturers use a special break in oil. It is designed to help all of the moving parts and especially the piston rings seat themselves to their mating parts. Change it too soon and you won’t get the maximum benefit from the special oil. Run it too long and you will get too much benefit from the special oil.